Specification for an SMD LC Filter MtronPTI P/N: LF9248 I. GENERAL & ELECTRICAL REQUIREMENTS: 1. CENTER FREQUENCY (FO): 2200MHz nominal 2. BANDWIDTH @ 1dB: 400MHz to 475.2MHz 3. INSERTION LOSS (@ peak of transmission): < 2.0dBa 4. REJECTION @ 1700MHz: 60dBc minimum @ 2750MHz: 60dBc minimum 5. ZIN/ZOUT: 50Ω nominal II. ENIVIRONMENTAL & PHYSICAL REQUIREMENTS: 1. TEMPERATURE RANGE Operating: 0°C to +50°C Storage: -40°C to +85°C 2. PACKAGE Note 1: SMD (see Figure 1 & 2) 3. SOLDERABILITY: Per EIAJ-STD-002 (see Figure 3) Note 1: Sn10 solder will be utilized throughout the construction and sealing of the LF9248. Therefore, it will support automated assembly processing. Including; Pick & Place, reflow soldering and post-reflow aqueous and non-aqueous wash. Note 2: The LF9248 can be supplied on tape & reel but the MOQ for tape & reel is 100-units. III. DIMENSIONS: Figure 2: Recommended PAD Layout Figure 1: Package Outline Drawing Rev. - 06/16/10 Page 1 of 2 Proprietary Document Information contained herein is proprietary to MtronPTI and is submitted in confidence. Information may not be copied or divulged without written permission from MtronPTI. Specification for an SMD LC Filter MtronPTI P/N: LF9248 IV. RECOMMENDED SOLDER REFLOW PROFILE: Figure 3: Recommended Reflow Profile Rev. - 06/16/10 Page 2 of 2 Proprietary Document Information contained herein is proprietary to MtronPTI and is submitted in confidence. Information may not be copied or divulged without written permission from MtronPTI.