RoHS FEATURES • Fast switching for high efficiency • Low forward voltage drop • High current capability • High surge current capability • Low reverse leakage current MECHANICAL DATA • Molded plastic body (UL 94V-0 rated) • Axial leads, solderable per MIL-STD-202, Method 208 • Polarity: Color band denotes cathode end • High temperature soldering 250°C/10 seconds • Weight: 0.40 gram DO-15 Dimensions in inches and (millimeters) MAXIMUM RATINGS & ELECTRICAL CHARACTERISTICS Rating at 25°C ambient temperature unless otherwise specified. Single phase, h alf w ave , 60 H z, r esistive o r i nductive l oad . For capactitive l oad, d erate c urrent b y 20% Symbol FR151 Maximum Repetitive Peak Reverse Voltage V RRM 50 100 200 400 Maximum RMS Voltage V RMS 35 70 140 Maximum DC blocking Voltage V DC 50 100 200 Maximum Average Forward Rectified Current .375” (9.5mm) Lead length@T A =55°C I F(AV) 1.5 A Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load (JEDEC method) I FSM 50 A VF 1.3 V IR 5.0 50 Parameter Maximum Instantaneous Forward [email protected] Maximum DC Reverse Current @ T A =25°C at rated DC Blocking voltage @ T A =100°C Maximun Reverse Recovery Time (Note 1) FR152 T RR Typical Thermal Resistance (Note2) Operating Temperature Range Storage Temperature Range FR153 FR156 FR157 Unit 600 800 1000 V 280 420 560 700 V 400 600 800 1000 V FR154 FR155 150 A 250 500 nS 25 °C/W TJ -55 to + 125 °C T STG -55 to + 150 °C NOTE: 1. Reverse Recovery Test conditions: IF=0.5A, IR=1.0A, IRR=0.25A. 2. Mounted on Cu-Pad Size 16mm x 16mm on P.C.B. Page 1 of 2 C3FR03 2011.10.05 RoHS RATING & CHARACTERISTIC CURVES 8.3ms Single half-sine wave JEDEC Method FIG.2-MAXIMUM FORWARD CURRENT DERATING AV E RAGE FORWARD C U RREN T (A) PEA K F ORWA RD S URGE C UR REN T ( A ) FIG.1-MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT Single phase half wave 60Hz resistive or inductive load 0.375”(9.5mm) Lead Length NUMBER OF CYCLES AT 60Hz FIG.4-TYPICAL REVERSE CHARACTERISTICS INSTA NTANEOUS REVERS E CURRENT (uA) I NS TA NTA NE OUS F ORWARD C URR EN T ( A) FIG.3-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS TJ=25°C Pulse Width=300us 1% Duty Cycle INSTANTANEOUS FORWARD VOLTAGE (V) TJ=125°C TJ=25°C PERCENT OF RATED PEAK REVERSE VOLTAGE (%) FIG.5-REVERSE RECOVER TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM 50W NON-INDUCTIVE (+) 50Vdc (approx) (-) 10W NON-INDUCTIVE DUT PULSE GENERATOR (NOTE 2) 1W NON INDUCTIVE OSCILLOSCOPE (NOTE 1) NOTES: 1. Rise Time=7ns max. Input Impedance=1megohom 22pF 2. Rise Time=10ns max. Source Impedance=50 ohms. Set Time Base For 5/10ns/cm Page 2 of 2 C3FR03 2011.10.05