● ● ● ● ● ● ● ● Features LED Driver 6W AC-DC Class II LED Power Supply 350mA to 700mA CC/CV Output ENEC, UL, RCM and CB Certified Universal Input Voltage Range Fused Input, Protected Output 3.75kVAC Isolation Low Cost 3 Year Warranty LIGHTLINE AC/DC-Converter with 3 year Warranty Description A compact universal input 6W constant current switching power module suitable for driving up to 12 high power LEDs.The output (dual constant voltage / constant current mode) current limit is fixed at 350mA, 500mA or 700mA. At lower output currents, the output is constant voltage. Selection Guide Part Number Nominal Input Voltage (VAC) Input Current at full load (mA) Output Voltage Range (VDC) Output Current (mA) Max # LEDs Efficiency typ. (%) RACD06-350 universal 120 2.5-24 350 6 x 1W 79 RACD06-500 universal 120 2.5-15 500 12 x 0.5W 70 RACD06-700 universal 120 2.5-12 700 3 x 2W 72 6 Watt Single Output Specifications (typical at 25°C and after warm up time unless otherwise specified ) Input Voltage Range Rated Power Input Frequency Range Power Factor Output Voltage Range 90-264VAC or 120-370VDC 6W nom. / 7.5W max. 47-63 Hz Full Load, 115VAC/230VAC 0.4 350mA CC 2.5 - 22VDC 0-300mA CV 24V typ. 500mA CC 2.5 - 13VDC 0-490mA CV 15V typ. 700mA CC 2.5 - 10VDC 0-600mA CV 12V typ. Inrush Current (<2mS) 115VAC/230VAC 10A max. Leakage Current 115VAC/240VAC - 60/50Hz 0.4mA typ. Input Fuse (Built-in) Standard T2A Input Current Full Load, Nominal Vin see table Output Current Accuracy (combined Tolerance, Load Regulation and Line Regulation) ±10% Minimum Load Open Circuit Protected 1 LED Output Ripple 0.2Ap-p max. Hold Up Time 18ms min. Operating Frequency 132kHz max. AC RMS Isolation Voltage I/P to O/P 3.75kV / 1 minute Temperature Coefficient ±0.02%/°C typ. Overload Protection 120% typ. Short Circuit Protection Continuous Current Limit Output Overvoltage Protection 350mA Version 24V Zener Diode Clamp 500mA Version 14V Zener Diode Clamp 700mA Version 12V Zener Diode Clamp Overtemperature Protection Shutdown, Automatic restart after cooling down Operating Temperature Range Ambient Temperature -20°C to +40°C (free air convection, according to CE/UL) Case Temperature 70°C max. Operating Temperature Range Ambient Temperature (free air convection, according to ENEC) Case Temperature RoHS 2011/65/EU 6/6 E340696 UL-8750 Certified EN 61347 Certified ENEC Certified RACD06 -20°C to +50°C 70°C max. continued on next page Refer to Application Notes www.recom-power.com REV: 0/2015 L-21 RACD06 Series LIGHTLINE AC/DC-Converter Specifications (typical at 25°C and after warm up time unless otherwise specified ) Storage Temperature Range -40°C to +85°C Humidity 95% RH max. IP Rating IP20, Indoor Use Only Weight 34g Packing Quantity 10pc PCB Material (UL94V-0) Case Material Designed to meet Standards (UL94V-0) Plastic Electrical Lighting, EMC Emissions EN55015:2006 + A1: 2007 + A2:2009 Limits for Harmonics Emissions EN 61000-3-2:2006 EMC Compatability: Flicker and Voltage Variations EN 61000-3-3:2006 Electrical Lighting: EMC Immunity EN 61547:1995 + A1:2000 Class II Power Supply Safety UL1310 FCC FCC18A LED Lighting Safety (E340696) UL8750 RCM (U21382) AS/NZS 61347.1:2002, IEC 61347-2-13 ENEC General Safety EN 61347-1: 2008 ENEC Safety of AC supplied Control Gear for LED Modules EN 61347-2-13: 2006 PSE J61347-1(H20), J61347-2-13(H21), J55015(H20) Certifications Design Lifetime Connections Plastic Resin with Fibreglass 25°C ambient AC Input LED Output >20 x 10³ hours in operation Screw terminal Screw Terminal Note: All LED Drivers may not be used without a load. They must be switched on the primary side only. Noncompliance may damage the LED or reduce its lifetime. Characteristics Constant Current (CC) and Constant Voltage (CV) Graph RACD06 RACD06-350 RACD06-700 RACD06-500 Maximum Number of LED drivers per circuit breakers CV 24V 22V Circuit Breaker 2.5V Output Current Typ 10A 16A 20A 25A C 221 247 337 430 230VAC, 1Ohm 90° phase angle B C 80 265 157 317 200 437 254 550 Nominal Current Limit Nominal Current Limit Nominal Current Limit 700mA Output Current 600mA 2.5V 10V Circuit Breaker Current 115VAC, 1Ohm 90° phase angle CV 12V CC Output Voltage 13V 500mA 490mA Output Current 350mA 300mA 2.5V Output Voltage 15V CV CC Output Voltage CC Condition CV Package Style and Pinning 15.0 13.0 PRI tc FC 12.0 SEC FC 11.5 Ø3.0 Connections 2 Mounting screws are included CN1 Function Tc = Case Temperature Measuring Point L VAC in (L) FC = Fixing Centers N VAC in (N) CN2 Function FC 64.0 58.0 35.0 + LED+ - LED- 1.50 21.0 Tolerance XX = +/-0.5mm XX.X = +/-0.25mm 68.0 The product information and specifications are subject to change without prior notice. RECOM products are not authorized for use in safety-critical applications (such as life support) without RECOM’s explicit written consent. A safety-critical application is defined as an application where a failure of a RECOM product may reasonably be expected to endanger or cause loss of life, inflict bodily harm or damage property. The buyer shall indemnify and hold harmless RECOM, its affiliated companies and its representatives against any damage claims in connection with the unauthorized use of RECOM products in such safety-critical applications. L-22 REV: 0/2015 www.recom-power.com