Features LED DRIVER ● ● ● ● ● ● ● High Output Voltage Universal AC Input Constant Current Operation Active Power Factor Correction IP67 Design for Indoor and Outdoor Use Compact Size Digital PWM and Analogue Voltage Dimming LIGHTLINE AC/DC-Converter with 5 year Warranty Description The new RACD150A LED drivers offer constant output currents of 1400mA, 1050mA or 700mA, with voltages from 60V up to 210V. The series supports dimming via PWM or 1-10V signals and is fully IP67 sealed for outdoor as well as indoor applications. With their wide input voltage range of 90 to 305VAC, the new drivers can be used worldwide on 115Vac, 230Vac and 277Vac supplies. The converters operate with full load efficiencies of more than 93%, feature low THD (15%) and active PFC with power factors exceeding 0.98, and are fully protected against short circuit, overload and over-temperature conditions. Applications include high-power area lighting as well as car parks, warehouse or security lighting. The LED drivers are UL8750 and EN61347 certified, comply with FCC and European EMC standards and come with a full 5 year warranty. 150 Watt Single Output Selection Guide Part Number Input Voltage Range (VAC) Rated Power (W) Output Voltage Range (VDC) Rated Output Current Efficiency (mA) (%) RACD150-700A 90-305 147 60-210 700 92 RACD150-1050A 90-305 150 60-143 1050 92 RACD150-1400A 90-305 150 60-107 1400 91 Specifications (measured at 230VAC and 25°C ambient temperature) Input Voltage Range Input Frequency Range Power Factor 90-305 VAC or 127-430VDC 47-63Hz. Full Load, 120VAC >0.98 Full Load, 240VAC >0.94 75% Load, 240VAC >0.90 DC Dimming Open = 100% DC 1-10V PWM Dimming Open = 100% Duty 10% - 100% Freq. 500Hz - 3000Hz Voltage Hi=10V, Low=0V THD (@ 230VAC/50Hz) 700A ±10% 1050A, 1400A ±11% Input Current 115VAC 2A max. 240VAC 1A max. Input/Output Isolation 3.75kVAC / 1min Input/Case Isolation 1.8kVAC / 1min Output/Case Isolation 0.5kVAC / 1min Leakage Current 230VAC <0.75mA Inrush Current 240VAC cold start 65A max. Voltage Tolerance ±10% Current Tolerance ±5% Ripple & Noise (@20MHz bandwidth) (1) 2000mV max. Over Voltage Protection 105 - 130% Rated Voltage Shutdown Mode Short Circuit Protection Constant current limit and recovers after fault condition is removed Over Temperature Protection Shutdown Mode Operating Temperature Range (Refer to Output Load Derating Curve) Ambient -40°C to +55°C (free air convection) Case Temperature 100°C max. Operation Humidity 20%-90% RH Non-Condensing Storage Temperature -40°C to +80°C Storage Humidity 10%-95% RH Vibration 2G 10min/1Cycle, Period for 60 min 10-500Hz continued on next page L-70 REV: 0/2015 RoHS 2011/65/EU 6/6 UL 8750 Certified EN 61347 Certified RACD150-A Derating-Graph (Ambient Temperature) Load 100% 80% 60% 40% 20% -40 -10 10 30 55 70 Ambient Temperature (°C) Refer to Application Notes www.recom-power.com RACD150-A Series LIGHTLINE AC/DC-Converter Specifications (measured at 115VAC / 230VAC and 25°C ambient temperature) Isolation Resistance IP Rating Safety Standards 100MΩ / 500VDC at 25°C IP67 Report: E340696 UL8750 Report: 12CA61289-1 EN61347-2-13 Report: 11036253 001 IEC61347-2-13 EN55015 FCC, Part 15 EN61000-3-2 Class C EN61000-3-3 EN61000-4-2, 3, 4, 5, 6, 11 EN61547 226*68*39mm 1.1kg 200 x 10³ hours UL/cUL LED Lighting Safety CE LVD Directive, Safety CB EMC Compatibility Standards Harmonic Current EMC Immunity Dimension Weight MTBF Notes: Note1: Note2: using MIL-HDBK-217F (25°C) Ripple and Noise are measured at 20MHZ bandwith by using a12“ twisted pair-wire terminated with 0.1uf & 47uf paralell application All LED Drivers may not be used without a load. They must be switched on the primary side only. Noncompliance may damage the LED or reduce its lifetime. DC Voltage Dimming Curve Ta=25°C Load (%) 100 80 PWM Dimming Curve Iout (%) Iout (%) 100% 100% 60 40 10% 10% 20 0 100 130 180 220 240 290 Vdim (V) 0 10% 10 Note: Resistor dimming is only possible with a digital potentiometer (current sink), like the RECOM REPOT Input Voltage (VAC)60Hz Ddim (%) 100% RACD150-A 90 1 Pule: Hi = 10V, Low = 0V Frequency: 500 - 3KHz Maximum Number of LED drivers per circuit breakers Condition Circuit Breaker Circuit Breaker Current Typ 10A 16A 20A 25A 115VAC, 1Ohm 90° phase angle C 5 8 9 12 230VAC, 1Ohm 90° phase angle B C 4 5 7 13 8 16 9 19 277VAC, 1Ohm 90° phase angle B C 5 9 8 15 9 18 11 21 Package Style and Pinning 226 203.2 7 52.0 300±20 AC/L AC/N Earth (Green/Yellow) 68.0 300±20 +V -V 34.2 4.2 +Dim (Blue) -Dim (White) 200 39.0 tc 16 88 The product information and specifications are subject to change without prior notice. RECOM products are not authorized for use in safety-critical applications (such as life support) without RECOM’s explicit written consent. A safety-critical application is defined as an application where a failure of a RECOM product may reasonably be expected to endanger or cause loss of life, inflict bodily harm or damage property. The buyer shall indemnify and hold harmless RECOM, its affiliated companies and its representatives against any damage claims in connection with the unauthorized use of RECOM products in such safety-critical applications. www.recom-power.com REV: 0/2015 L-71