PRODUCT DATASHEET ET-8DI2-8AI2 ET-8DI2-8DO2 EtherTRAKTM COMBINATION I/O Select the ET-8DI2-8AI2 when you need to monitor both discrete and analog inputs over an Ethernet network or ET-8DI2-8DO2 when you need a mix of discrete inputs and outputs for control at a remote location. PRODUCT HIGHLIGHTS Single module compact solutions for small stations Lowest cost solution when mixed I/O is needed Ethernet or RS485 Modbus capability Ideal “RTU” for networked systems PERFORMANCE SPECIFICATIONS 8 discrete inputs Nominal discrete input range 12/24 VDC/VAC Discrete input characteristics, same as ET-16DI2 8 analog inputs (-8AI2 module only) Analog input range 4-20 mA Analog input resolution 14 bits (0.01%) Analog input characteristics, same as ET-16AI2 8 discrete outputs (-8DO2 module only) Max. output current per channel 1 Amp Discrete output characteristics, same as ET-16DO2 Filtered Mode ON/OFF delay 25 mS Filtered Mode count feature 10 Hz Maximum Fast Mode count feature 100 Hz Max (2 kHz on channel 1) Required supply voltage 10-30 VDC (0.75 watt typical) Operating temperature range -30 to 70° C Storage temperature range -40 to 85° C Humidity (non-condensing) 5 to 95% ET-8DI2-8AI2 RS485 PORT FOR I/O EXPANSION 32 Max. RemoteTRAK modules (up to 512 I/O) Baud rate: 38,400 bps Recommended distance of up to 0.5 mile Protocol: Sixnet “I/O for Windows”, Modbus ASCII & RTU Isolation (from Ethernet port) 1200 Volts RMS 1 minute ET-8DI2-8DO2 ORDERING INFORMATION ET-8DI2-8AI2-H 8DI and 8AI with wiring base ET-8DI2-8DO2-H 8DI and 8DO with wiring base ET-8DI2-8AI2-M Replacement module only ET-8DI2-8DO2-M Replacement module only All specifications are subject to change. Consult factory for latest info. Sixnet Technology Park • 331 Ushers Road • Ballston Lake, NY 12019 • USA 1.518.877.5173 • Fax 1.518.877.8346 • [email protected] SOLUTIONS FOR YOUR INDUSTRIAL NETWORKING CHALLENGES DATASHEET ET-8DI2-8AI2 / ET-8DI2-8DO2 May 20, 2009 WWW.SIXNET.COM