Filename: tfs 90b.doc Version 1.5 VI TELEFILTER 11.01.2008 Filter specification TFS 90B 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: 23 0 °C dBm 1000 Ω || -18,0 pF 900 Ω || -17,9 pF Characteristics Remark: The nominal frequency fN is fixed at 90,0 MHz. The insertion loss ae is defined as loss value determined at fN. Reference level for the relative attenuation arel of the TFS 90B is the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 2 dB filter attenuation level relative to the insertion loss ae. All specified data are met within the operating temperature range. Data typ. value Insertion loss (reference level) ae 10,9 Nominal frequency fN - Centre frequency fC 90,0 PB Passband p-p Pass band ripple dB tolerance / limit max. MHz - 13,0 dB 90,0 MHz fN ± max. 1,8 MHz 2 dB 0,7 dB 3,8 4,2 MHz MHz 0,3 0,6 dB dB max. max. 0,6 2,5 dB dB dB dB dB dB dB dB min. min. min. min. min. min. 40 30 25 6,5 40 30 dB dB dB dB dB dB µs max. Bandwidth 1 3 dB dB arel Relative attenuation fN fN ± fN fN fN fN fN fN ± ± ± + + 1,5 80 15 10 6 15 80 - ... fN MHz ... fN ± ± 1,5 1,8 MHz MHz MHz MHz MHz MHz MHz MHz ± ± ± + + 15 10 6 2,5 80 910 MHz MHz MHz MHz MHz MHz ... ... ... ... ... ... fN fN fN fN fN fN Group delay 48 38 30 13 44 38 0,65 at fN 0,75 µs Group delay variation in fN ± 1,2 MHz p-p 80 ns max. 120 ns Group delay variation in PB p-p 100 ns max. 180 ns dBm min. 30 dBm max. 6 dBm 42 Intermodulation ** - Input power level Operating temperature range OTR Storage temperature range Temperature coefficient of frequency TCf *** - -40 °C..... +85 °C - -55 °C..... +85 °C -33 ppm/K - *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) fin1= 89,4 MHz; fin2= 89,7 MHz; Pin= 0 dBm fmeasurement = 90,0 MHz ***) ∆fc(Hz) = TCf(ppm/K) x (T - To) x fTo (MHz). Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 90b.doc Version 1.5 VI TELEFILTER 11.01.2008 Filter specification TFS 90B 2/5 0 1.68 -1 1.56 -12 -2 1.44 -18 -3 1.32 -24 -4 1.2 -5 1.08 -6 0.96 -42 -7 0.84 -48 -8 0.72 -54 -9 0.6 -30 -36 -60 40 50 60 70 80 90 100 frequency in MHz 110 120 130 -10 88 140 88.4 88.8 89.2 89.6 90 90.4 frequency in MHz 90.8 91.2 91.6 delay in µs 0 -6 magnitude in dB magnitude in dB Filter characteristic 0.48 92 Construction and pin connection (All dimensions in mm) S 90B ● W02 3 Date code 2 Max. 1 Input Input RF Return Ground Ground Ground Ground Output Output RF Return Ground Ground Ground Ground Date code: W X A ... Year + week 2008 2009 2010 1 5,2 Max. 2,54 ±0,2 7,2 Max. 2,54 ±0,2 1 1 2 3 4 5 6 7 8 9 10 11 12 0,80 Base material ceramic; plating Au >1,0µm over Ni >2µm 50 Ohm Test circuit 1 L1 2 7 SAW L2 L3 8 L4 3, 4, 5, 6, 9, 10, 11, 12 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 90b.doc Version 1.5 VI TELEFILTER 11.01.2008 Filter specification TFS 90B 3/5 Stability characteristics, reliability After the following tests the filter shall meet the whole specification: 1. Shock: 3000g shock, per MIL-STD 883, procedure 2002.4, condition C 5000g shock, per MIL-STD 883, procedure 2002.4, condition D 2. Vibration: 20g, per MIL-STD 883, procedure 2007.3, condition A 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: three times max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 – 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer: 3000 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction Tape (all dimensions in mm) W : 16,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,1 F : 7,50 ± 0,1 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 8,00 ± 0,1 D1(min) : 1,50 Ao : 5,50 ± 0,1 Bo : 7,50 ± 0,1 Ct : 13,5 ± 0,1 P1 Date Code Po Do P2 W G Ct Bo F G E t Ko Typ PIN Marker D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 16,4 +2/-0 W2(max) : 22,4 N(min) : 50 C : 13,0 +0,5/-0,2 C A N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 90b.doc Version 1.5 VI TELEFILTER 11.01.2008 Filter specification TFS 90B 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 90b.doc VI TELEFILTER Version 1.5 Filter specification 11.01.2008 TFS 90B 5/5 History Version Reason of Changes Name Date 1.0 - generation of development specification Strehl 12.05.2006 1.1 - extend of storage temperature range Strehl 17.05.2006 1.2 - terminating impedances, typical values, filter characteristics and matching configuration added - frequencies of input signals for intermodulation measurements corrected Pfeiffer 29.08.2006 1.3 - temperature coefficient of frequency and typical values corrected - change of relative attenuations Pfeiffer 31.08.2006 1.4 - add plating in construction Strehl 15.05.2007 1.5 - change stability characteristics Strehl 11.01.2008 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.