Filename: tfs 80g.doc Version 1.3 VI TELEFILTER 14.11.2005 Filter specification TFS 80G 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: Source impedance: Load impedance: 23 0 °C dBm 700 Ω || -1,3 pF 700 Ω || -1,3 pF 100 Ω 100 Ω Characteristics Remark: The reference level for the relative attenuation arel of the TFS 80G is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 80,0 MHz without any tolerance. The given values for both the relative attenuation arel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc. Data typ. value Insertion loss (reference level) ae 2,6 Nominal frequency fN - Centre frequency fC 80,0 PB Passband Pass band ripple (p-p) fN fN + 120 60 kHz kHz dB max. 4,0 80,0 MHz dB MHz ± 5,0 fN - kHz 0,2 dB max. 1,5 dB 0,2 0,5 dB dB max. max. 1,5 3 dB dB dB dB min. min. 25 25 dB dB max. 10 dBm arel Relative attenuation fN fN tolerance / limit ... fN ... fN ± ± 5 10 kHz kHz ... fN ... fN + 60 120 kHz kHz - Input power level Operating temperature range OTR - 0 °C ... + 50 °C - Storage temperature range Frequency inversion temperature Temperature coefficient of frequency 33 37 TCf ** -40 °C ... + 85 °C 30 °C -0,036 ppm/K 2 - *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) ∆fc(Hz) = TCf(ppm/K2) x (T - To)2 x fTo (MHz). Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 80g.doc Version 1.3 VI TELEFILTER 14.11.2005 Filter specification TFS 80G 2/5 Filter characteristic 0 0 -10 -20 -30 -5 magnitude in dB magnitude in dB -40 -50 -60 -10 -70 -80 -90 -100 79.6 79.7 79.8 79.9 80 frequency in MHz 80.1 80.2 80.3 80.4 -15 80.5 79.95 79.96 79.97 79.98 79.99 80 frequency in MHz 80.01 80.02 80.03 80.04 Construction and pin connection (All dimensions in mm) TFS 80G ● T46 6,8Max. 13,6Max. 1 2,54 ±0,15 2,54 ±0,15 1 2 3 4 2,0Max. 1,5 Date code 12 5 11 6 1 2 3 4 5 6 7 8 9 10 11 12 Ground Ground Ground Ground Output Output Ground Ground Ground Ground Input Input Date code: T U V ... Year + week 2005 2006 2007 10 9 8 7 0,8 0,1 100 Ω Test circuit 11 L1 C1 12 5 SAW L3 6 L2 C2 L4 1, 2, 3, 4, 7, 8, 9, 10 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 80g.doc Version 1.3 VI TELEFILTER 14.11.2005 Filter specification TFS 80G 3/5 Stability characteristics, reliability After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: twice max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 – 3, with exeption of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters peer reel: reel of empty components at start: reel of empty components at start including leader: trailer: 1700 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction Tape (all dimensions in mm) W : 24,00 +0,30/-0,10 Po : 4,00 ± 0,1 Do : 1,50 +0,1/0 E : 1,75 ± 0,10 F : 11,50 ± 0,10 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 12,00 ± 0,1 D1(min) : 1,50 Ao : 7,10 ± 0,10 Bo : 13,90 ± 0,10 Ct : 21,5 ± 0,1 t P1 Date Code Po P2 W G Ct Bo F G E Do Ko Typ PIN Marker D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 24,4 +2/-0 W2(max) : 30,4 N(min) : 60 C : 13,0 +0,5/-0,2 A C N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 80g.doc Version 1.3 VI TELEFILTER 14.11.2005 Filter specification TFS 80G 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 80g.doc VI TELEFILTER Version 1.3 Filter specification 14.11.2005 TFS 80G 5/5 History Version Reason of Changes Name Date 1.0 Generation of development specification Strehl 30.05.2005 1.1 Change test circuit from 50Ω single ended to 100Ω differential environment Strehl 01.07.2005 1.2 Generation of filter specification; added typical values; added filter characteristic Martens 02.11.2005 1.3 Change stability characteristics, reliability Strehl 14.11.2005 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.