Filename: tfs 140ap.doc Version 1.3 VI TELEFILTER 15.11.2006 Filter specification TFS 140AP 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: 23 0 °C dBm 102 Ω || -38 pF 99 Ω || -36 pF Characteristics Remark: The nominal frequency fN is fixed at 140,0 MHz. The insertion loss ae is defined as loss value determined at fN. Reference level for the relative attenuation arel of the TFS 140AP is the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 20 dB filter attenuation level relative to the insertion loss ae. All specified data are met within the operating temperature range. Data typ. value Insertion loss (reference level) ae Nominal frequency fN - Centre frequency fC 140 PB Passband dB dB 8,8 130,0 30,0 max. 10,0 140,0 MHz dB MHz - MHz fN dB 24,8 45,9 ± 8,8 MHz max. 1 dB MHz MHz min. max. 22,0 60,0 MHz MHz 0,3 2 47 42 dB dB dB dB max. max. min. min. 1 3 40 40 dB dB dB dB 35 ns max. 160 ns max. 0 arel Relative attenuation ± + dB BW Bandwidth fN fN fN fN 22,9 0,3 Pass band ripple 3 40 7,6 tolerance / limit … fN MHz ... fN MHz ... fN MHz ... fN Group delay ripple within PB ± ± + 8,8 11,0 30,0 370,0 MHz MHz MHz MHz p-p - Input power level Operating temperature range OTR Storage temperature range Temperature coefficient of frequency TCf ** - - 5 °C ... + 80°C - - 55 °C ... + 80°C -95 dBm ppm/K *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) ∆f(Hz) = TCf(ppm/K) x (T-T0) x fTo(MHz) Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 140ap.doc Version 1.3 VI TELEFILTER 15.11.2006 Filter specification TFS 140AP 2/5 0 1.45 -0.6 1.33 -14 -1.2 1.21 -21 -1.8 1.09 -28 -2.4 0.97 -3 0.85 -3.6 0.73 -49 -4.2 0.61 -56 -4.8 0.49 -63 -5.4 0.37 -35 -42 -70 40 60 80 100 120 140 160 frequency in MHz 180 200 220 -6 126 240 128.8 131.6 134.4 137.2 140 142.8 frequency in MHz 145.6 148.4 151.2 delay in µs 0 -7 magnitude in dB magnitude in dB Filter characteristic 0.25 154 Construction and pin connection (All dimensions in mm) TFS 140AP ● U46 6,8Max. 13,6Max. 1 2,54 ±0,15 2,54 ±0,15 1 2 3 4 2,0Max. 1,5 Date code 12 5 11 6 10 9 8 7 1 2 3 4 5 6 7 8 9 10 11 12 Ground Ground Ground Ground Output Output RF Return Ground Ground Ground Ground Input Input RF Return Date code: U V W ... Year + week 2006 2007 2008 0,1 0,8 50 Ohm Test circuit 11 L1 12 5 SAW L2 L3 6 L4 1,2,3,4,7,8,9,10 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 140ap.doc Version 1.3 VI TELEFILTER 15.11.2006 Filter specification TFS 140AP 3/5 Stability characteristics, reliability After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: three times max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 – 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer: 1700 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction P1 Tape (all dimensions in mm) W : 24,00 +0,30/-0,10 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,10 F : 11,50 ± 0,10 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 12,00 ± 0,1 D1(min) : 1,50 Ao : 7,10 ± 0,10 Bo : 13,90 ± 0,10 Ct : 21,5 ± 0,1 Date Code Do P2 W G Ct Bo F G E t Po Ko Typ PIN Marker D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 24,4 +2/-0 W2(max) : 30,4 N(min) : 60 C : 13,0 +0,5/-0,2 C A N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 140ap.doc Version 1.3 VI TELEFILTER 15.11.2006 Filter specification TFS 140AP 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 140ap.doc VI TELEFILTER Version 1.3 Filter specification 15.11.2006 TFS 140AP 5/5 History Version Reason of Changes Name Date 1.0 - Generation of development specification Strehl 17.05.2006 1.1 - Correct bandwidth from 30dB to 40dB Strehl 23.05.2006 1.2 - Change construction Strehl 24.07.2006 1.3 - Created filter specification - Added terminating impedances - Added typical values - Added temperature coefficient of frequency - Added filter characteristic - Changed construction - Added test circuit - Changed packing Chilla 15.11.2006 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.