MP1C Series This float switch is designed specially to maintain the air cushion in autoclaves and is available in two different versions 1” or 1”1/4.diameter. Thanks to its small diameter it can be introduced into the tank through a coupling and mounted either horizontally or vertically (with counterweight).The level switch action point is determined by the cable length with the entry point (if horizontal) or to the application point (if vertical).When the tank water level rises , the switch gives the starting up command to the compressor contactor or to the compressed air valve, which then stops the pump with an auxiliary contact. When the water / air level stabilises at the desired position, the switch stops the compressor and starts the pump. Technical Specifications Contact Form Material Temp Range °C °F Cable Standard cable covering Max. working pressure Electrical Specifications Power Rating Max Switching Voltage Max Switching Current Max. Resistive MP1C-3 MP1C-5 C/O High Density Polyethylene 0 / +55 + 32 / +131 3 metre 5 metre PVC 3x1 A05 VVF Rf60 10 bar 3VA 60Vac 0.25 A It is necessary to use an auxiliary relay, when switching any significant load. • For compressor receivers or pressurised tanks • Installation through G1”or G1”1/4 • Supplied with gland & counterweight • Mount through side or top of tank MECHANICAL Off - On Differential 5% On - Off Minimum Cable Pivot length 120mm ISO 9001C E R T I F IED Cynergy3 Components Ltd 7 Cobham Road Ferndown Industrial Estate Wimborne Dorset BH21 7PE Tel: +44 (0) 1202 897969 [email protected] www.cynergy3.com © 2011 Cynergy3 Components, All Rights Reserved. Specifications are subject to change without prior notice. Cynergy3 Components and the Cynergy3 Components logo are trademarks of Cynergy3 Components Limited. ISO 9001C E R T I F IED www.cynergy3.com © 2011 Cynergy3 Components, All Rights Reserved. Specifications are subject to change without prior notice. Cynergy3 Components and the Cynergy3 Components logo are trademarks of Cynergy3 Components Limited.