HN Male Connector Clamp/Solder Attachment For RG59, RG62 TECHNICAL DATA SHEET PE4479 HN Male Connector Clamp/Solder Attachment For RG59, RG62 Configuration Connector Connector Specification Connector Interface Type Cable Attachment Method (Shield/Contact) Body Style Electrical Specifications Impedance, Ohms HN Male MIL-C-39012 RG59,RG62 Clamp/Solder Straight 50 Mechanical Specifications Temperature Operating Range, deg C -65 to +165 Size Length, in [mm] Width/Dia., in [mm] 1.53 [38.86] 0.9 [22.86] Weight, lbs [g] 0.11 [49.9] Connector Type Contact Material and Plating Contact Plating Specification Coupling Nut Material and Plating Body Material and Plating Dielectric Type HN Male Silver QQ-S-365 Brass, Nickel Brass, Nickel Teflon . Compliance Certifications (visit www.Pasternack.com for current document) RoHS Compliant Yes Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price, inventory and certifications: HN Male Connector Clamp/Solder Attachment For RG59, RG62 PE4479 PE4479 REV 01 1 HN Male Connector Clamp/Solder Attachment For RG59, RG62 TECHNICAL DATA SHEET PE4479 Plotted and Other Data Notes: Values at 25 °C, sea level HN Male Connector Clamp/Solder Attachment For RG59, RG62 from Pasternack Enterprises has same day shipment for domestic and International orders. Our RF, microwave and fiber optic products maintain a 99% availability and are part of the broadest selection in the industry. Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price, inventory and certifications: HN Male Connector Clamp/Solder Attachment For RG59, RG62 PE4479 URL: http://www.pasternack.com/hn-male-standard-rg59-rg62-connector-pe4479-p.aspx PE4479 REV 01 2 © 2013 Pasternack Enterprises All Rights Reserved 2. FORM BRAID OVER CLAMP NUT (3). TRIM BRAID BACK TO SHOULDER. CUT DIELECTRIC TO DIMENSION SHOWN. DO NOT NICK CENTER CONDUCTOR. SOLDER CONTACT TO CENTER CONDUCTOR. REMOVE EXCESS SOLDER. DO NOT OVER HEAT DIELECTRIC. INSERT CABLE ASSEMBLY INTO BODY & TIGHTEN. 1. SLIDE CLAMP NUT (1) & GASKET (2) OVER CABLE. STRIP CABLE AS SHOWN. DO NOT NICK BRAID WHILE CUTTING JACKET. COMB OUT BRAID. TAPER END OF BRAID TO PERMIT ASSEMBLY OF BRAID CLAMP (3). SLIDE BRAID CLAMP (3) OVER BRAID & SEAT AGAINST CABLE. ASSEMBLY PROCEDURES PE4479 REV 01 REV. - CAD FILE 070203 SCALE N/A SIZE A 2233 NOTES: 1. UNLESS OTHERWISE SPECIFIED ALL DIMENSIONS ARE NOMINAL. 2. ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE AT ANY TIME. 3. DIMENSIONS ARE IN INCHES [mm]. 4. FITS MIL-C-17 AND EQUIVALENT CABLES. FSCM NO. 53919 PE4479 DWG TITLE HN Male Connector Clamp/Solder Attachment For RG59, RG62 PE4479 CAD Drawing 3