SMB Jack Bulkhead Connector Clamp/Solder Attachment For PE-SR405AL, PE-SR405FL, RG405 TECHNICAL DATA SHEET PE4362 SMB Jack Bulkhead Connector Clamp/Solder Attachment For PE-SR405AL, PE-SR405FL, RG405 Configuration Connector Connector Specification Connector Interface Type Cable Attachment Method (Shield/Contact) Body Style Mount Method SMB Jack MIL-STD-348A PE-SR405AL,PE-SR405FL,RG405 Clamp/Solder Straight Bulkhead Electrical Specifications Impedance, Ohms 50 Mechanical Specifications Size Length, in [mm] Width/Dia., in [mm] 0.695 [17.65] 0.25 [6] Weight, lbs [g] 0.005 [2.27] Connector Type Contact Material and Plating Contact Plating Specification Body Material and Plating Body Plating Specification Dielectric Type SMB Jack Brass, Gold 30µ in. minimum Brass, Nickel 100µ in. minimum Teflon . Compliance Certifications (visit www.Pasternack.com for current document) RoHS Compliant Yes Plotted and Other Data Notes: Values at 25 °C, sea level Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price, inventory and certifications: SMB Jack Bulkhead Connector Clamp/Solder Attachment For PE-SR405AL, PE-SR405FL, RG405 PE4362 PE4362 REV 1 SMB Jack Bulkhead Connector Clamp/Solder Attachment For PE-SR405AL, PE-SR405FL, RG405 TECHNICAL DATA SHEET PE4362 SMB Jack Bulkhead Connector Clamp/Solder Attachment For PE-SR405AL, PE-SR405FL, RG405 from Pasternack Enterprises has same day shipment for domestic and International orders. Our RF, microwave and fiber optic products maintain a 99% availability and are part of the broadest selection in the industry. Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price, inventory and certifications: SMB Jack Bulkhead Connector Clamp/Solder Attachment For PE-SR405AL, PE-SR405FL, RG405 PE4362 URL: http://www.pasternack.com/smb-jack-standard-pe-sr405al-pe-sr405fl-rg405-connector-pe4362-p.aspx PE4362 REV 2 © 2013 Pasternack Enterprises All Rights Reserved PE4362 REV 3. SOLDER CONTACT TO CENTER CONDUCTOR. CLEAN EXCESS SOLDER. SLIDE ASSEMBLY INTO BODY & TIGHTEN. 2. PUSH SLEEVE (2) OVER CABLE UNTIL SLEEVE (2) BOTTOMS ON OUTER CONDUCTOR WITH CENTER CONDUCTOR PROTRUDING THROUGH HOLE. SOLDER SLEEVE (2) TO OUTER CONDUCTOR. 1. STRIP CABLE AS SHOWN. DO NOT NICK CENTER CONDUCTOR & DIELECTRIC. SLIDE CLAMP NUT (1) OVER CABLE. ASSEMBLY PROCEDURES REV. - CAD FILE 081604 SCALE N/A SIZE A 2233 NOTES: 1. UNLESS OTHERWISE SPECIFIED ALL DIMENSIONS ARE NOMINAL. 2. ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE AT ANY TIME. 3. DIMENSIONS ARE IN INCHES [mm]. 4. FITS MIL-C-17 AND EQUIVALENT CABLES. FSCM NO. 53919 PE4362 DWG TITLE SMB Jack Bulkhead Connector Clamp/Solder Attachment For PE-SR405AL, PE-SR405FL, RG405 PE4362 CAD Drawing 3