RID-50 50W D u a l Ou t p u t S w it c hi ng P ow er S upply series Isolated Output Universal AC input Protections: Short circuit / Overload / Over voltage Cooling by free air convection LED indicator for power on All using 105°C long life electrolytic capacitors Model Number Output Volts Output Amps DUAL OUTPUT RID-50A RID-50B 5 Volts(DC) 12 Volts(DC) 5 Volts(DC) 24 Volts(DC) WWW.ASTRODYNE.COM 6 Amps 2 Amps 4 Amps 1.4 Amps Ripple & Noise Min Load 80mV pk-pk 120mV pk-pk 80mV pk-pk 150mV pk-pk 0.3 ~ 6Amps 0.2 ~ 3Amps 0.3 ~ 6Amps 0.2 ~ 2Amps Line Reg Volt Tolerance ±0.5% ±1.5% ±0.5% ±1.5% ±2.0% ±8.0% ±2.0% +8,-4% ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 RID-50 50W D u a l Ou t p u t S w it c hi ng P ow er S upply ENVIRONMENTAL SPECIFICATIONS INPUT SPECIFICATIONS Input Voltage Range Frequency Range Inrush Current, typ: (cold start) Input Current Leakage current 90 ~ 264 VAC; 125~373 Volts(DC) 47-63 Hz 33 Amps / 230VAC 1.3 Amps. @ 115VAC 0.8 Amps. @ 230VAC < 2mAmps /240VAC OUTPUT SPECIFICATIONS Voltage and Current Line Regulation (Note 3) Load Regulation (Note 4) Voltage Tolerance (Note 2) Ripple/Noise (Note 1) Hold Up Time @ FL Setup, Rise Time @ FL Over Voltage Protection Over Current Protection DC Voltage Adjust series See Selection Chart See Selection Chart 0.5% See Selection Chart See Selection Chart 60mS/230VAC 14mS/115VAC 500ms, 20m/230VAC 1200mS, 30mS/115VAC 5Volts only: 5.75 ~ 6.75VDC Hiccup mode, auto recover 110 ~ 150% rated output power Hiccup mode, auto recover 5Volts only: 4.75 ~ 5.5Volts(DC) Oper. Temperature Storage Temperature Relative Humidity Temperature Coefficient MTBF Vibration -25°C to +70°C (See Derate Curve) -40°C to +85°C, 10~95% RH 20 to +90% RH non cond 0.03% / °C (0-50°C) on +5V output 172.6 KHrs min,MIL-HDBK-217F (25°C) 10~500Hz, 5G10min./1cycle, period for 60min. each along X, Y, Z axes PHYSICAL SPECIFICATIONS Size Millimeters 99 x 97 x 36 Inches 3.90” x 3.82 ” x 1.42 ” Weight 14.46 oz (410g) Note 1. Ripple & noise are measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 2. Tolerance : includes set up tolerance, line regulation and load regulation. 3. Line regulation is measured from low line to high line at rated load. 4. Load regulation is measured from 20% to 100% rated load, and other output at 60% rated load. GENERAL SPECIFICATIONS Safety Insulation Resistance EMI Harmonic Current Efficiency Isolation EMS UL60950-1 TUV EN60950-1 Approved ≥ 100MΩ @ 500VDC/25 °C/70%RH Compliance to EN55022B(CISPR22B) Compliance to EN61000-3-2,-3 80% 3000VAC Input - Output 1500VAC Input - Ground 500VAC Output - Ground Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, EN60601-1-2, (EN50082-2), heavy industry level, criteria A All specifications are typical at nominal input, full load, and 25°C unless otherwise noted WWW.ASTRODYNE.COM Astrodyne products are not authorized or warranteed for use as critical components in life support systems, equipment used in hazardous environments, nuclear controls systems, or other mission-critical applications. ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 50W D u a l Ou t p u t S w it c hi ng P ow er S upply WWW.ASTRODYNE.COM RID-50 series ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 50W D u a l Ou t p u t S w it c hi ng P ow er S upply WWW.ASTRODYNE.COM RID-50 series ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458