Bel Stewart Connector 37 SERIES SHIELDED UNIBODY PLUG ASSEMBLY INSTRUCTIONS 11118 Susquehanna Trail South Glen Rock, PA 17327 1 2 3 Strip off approx. 1.25” of cable jacket Fold shield and drain back over jacket Trim insulating film layer 0.5” 4 Untwist and Straighten pairs 7 Slide wires into place. Hold housing at slight angle to cable as shown Page 1 of 1 5 6 Arrange pairs (TIA 568-B shown) and trim at 0.5” Insert wires into housing 8 Make sure all wires are visible through end of plug 9 Crimp contacts and strain relief, then trim shield and drain wire. MN370058-A1