Bel Stewart Connector

UNSHIELDED 30 SERIES PLUG
ASSEMBLY INSTRUCTIONS
Bel Stewart Connector
11118 Susquehanna Trail South Glen Rock, PA 17327
STEWART CONNECTOR UNSHIELDED 30 SERIES PLUG ASSEMBLY
INSTRUCTIONS
Assembly steps 1 – 8:
1
2
Remove approximately 1 inch of
Cable Jacket
4
Trim Wire Ends at 90°, Approx.
9/16” From Jacket
Untwist the pairs and Straighten
the Wires
Position Wires into Correct
Configuration (568-B Shown)
5
6
Insert Wires Along Plug Top,
Maintaining Correct Alignment
Inspect The Plug; Wires Should Be
Visible from Plug Front
7
Crimp Contacts and Strain Relief
Page 1 of 1
3
8
Construction Complete
MN300015-A1