Bel Stewart Connector 37 SERIES UNSHIELDED PLUG W/MANAGEMENT BAR ASSEMBLY INSTRUCTIONS 11118 Susquehanna Trail South Glen Rock, PA 17327 37 SERIES UNSHIELDED PLUG WITH MANAGEMENT BAR ASSEMBLY INSTRUCTIONS Assembly steps 1 – 11: 2 1 Remove approximately 1 inch of Cable Jacket 3 Align pairs (TIA 586-B shown) Spread out wire pairs Even Row 4 5 6 Odd Row Trim Odd wires (1, 3, 5, & 7) at an angle A264 Management Bar –Odd and Even rows Slide trimmed Odd conductors into Odd row of Management Bar 9 7 Press Even wires (2, 4, 6, & 8) into place in Management Bar Page 1 of 2 8 Trim wires to approx. 7/16” from front of cable jacket Insert cable into plug housing. Make sure wire ends are visible thru end of plug housing MN370054-A0 Bel Stewart Connector 37 SERIES UNSHIELDED PLUG W/MANAGEMENT BAR ASSEMBLY INSTRUCTIONS 11118 Susquehanna Trail South Glen Rock, PA 17327 37 SERIES UNSHIELDED PLUG WITH MANAGEMENT BAR ASSEMBLY INSTRUCTIONS Assembly steps 1 – 11 (Cont.): 11 10 Crimp contacts and strain relief Plug assembly is complete Alternate Steps For 370808M2-MB Management Bar: Even Row 5a 7a Odd Row Odd and Even Rows Page 2 of 2 Trim Even wires (2, 4, 6, & 8) even with bottom of Management Bar and insert into Even row MN370054-A0