SERIES POWER ENTRY MODULE EMI FILTERS V D E SPECIFICATIONS INTRODUCTIONS 1. Power module incorporates an IEC connector, single or double-fuse (IEC 5 x 20mm) holder, and double-pole power switch, plus an EMI filter all-in-one easy-to-install unit. 2. All part numbers are UL recognized, CSA certified and VDE approved. 3. Switch electrical lifetime: 10,000 cycles. Maximum inrush current: 50A. 1. Maximum leakage current each line-to-ground @ 115VAC 60Hz: 0.2mA @ 250VAC 50Hz: 0.4mA 2. Hipot rating (one minute) line-to-ground: 2250VDC line-to-line: 1450VDC 3. Operating frequency: 50/60Hz 4. Rated voltage: 115/250VAC COMPONENTS PART NO. 01IB2D 01IB2S 03IB2D 03IB2S 06IB2D 06IB2S Cx (uF) L (mH) Cy(pF) R( ) ELECTRICAL SCHEMATIC 7.5 0.22 2.0 2200 1M X 0.45 MINIMUM INSERTION LOSS IN dB FIG. A COMMON MODE (L-G) IN 50 OHM SYSTEM CURRENT FREQUENCY-MHz RATING 0.15 0.50 1.0 5.0 10 30 1A 28 40 40 35 35 25 3A 15 30 35 35 40 25 6A 8 15 20 32 40 25 DIFFERENTIAL MODE (L-G) IN 50 OHM SYSTEM 1A 10 20 28 35 38 35 3A 8 15 20 30 35 35 6A 8 15 15 30 35 35 X FIG. B DELTA PART NO. RATED CURRENT 115VAC 250VAC IEC CONNECTOR FUSE DOUBLE-POLE POWER SWITCH ELECTRICAL SCHEMATIC 01IB2D 1A 1A D 03IB2D 06IB2D 3A 6A 3A 6A D D DOUBLE DOUBLE FIG. A 01IB2S 1A 1A D 03IB2S 06IB2S 3A 6A 3A 6A D D SINGLE DOUBLE FIG. B UL, CSA, VDE approved current rating: UL/CSA-10A both at 125VAC and 250VAC: VDE-4A/250VAC. M3 R0.1 R2.5 2.57REF. IB2D +0.02 2.360 +0.5 60.00 0.57 0.04 14.5 1.0 SUGGESTED MOUNTING CUTOUT 2.2MAX. 56.0MAX. 2.34MAX. 59.5MAX. 4-15 +0.02 1.16-0 +0.5 29.0-0 1.575 0.02 40.0 0.5 2.0MAX. 50.7MAX. 2.6MAX. 66.0MAX. 0.13(2X) 3.3(2X) 1.575 0.004 40.0 0.1 65.7REF. MECHANICAL CONSTRUCTION UNIT: INCH mm POWER ENTRY MODULE FILTERS TYPE & RATED CURRENT