DTSPU131 SERIES 130 Watts AC/DC Desktop Power Supplies Single Output Rev B Size: 7.44in x 3.52in x 1.79in (188.9mm x 89.5mm x 45.5mm) OPTIONS FEATURES • Output Voltage • Output Cable • ON/OFF Switch • • • • • APPLICATIONS • • • • • • Class I Single Output RoHS Compliant IEC-320-C14 Input Inlet Over Voltage, Short Circuit, and Over Load Protection • • • • • • Efficiency Level VI (12V and 24V models) Active Power Factor Correction Optional Output Connectors Available Output Voltages available from 12VDC to 55VDC Optional On/Off Switch Wide Input Voltage Range: 90 to 260VAC, 47~63Hz DESCRIPTION The DTSPU131 series of AC/DC desktop switching power supplies provides 130 watts of continuous output power. This series consists of single output models with a 90~260VAC input voltage range and an IEC-320-C14 input inlet connector for worldwide applications. These supplies also have short circuit, over voltage, and over load protection. All units are UL94V-1, RoHS compliant, and 12V and 24V models are Energy Star 2.0 Level VI compliant, while the rest are compliant to Level V. All models meet FCC Part-15 class B and CISPR-22 EN55022 class B emission limits and have UL/cUL (UL 60950-1) and TUV/T-mark (EN 60950-1) safety approvals. This series also meets new CE requirements and are 100% burn-in tested. Printer Industrial PC Power Tools DC Moto AV Equipment LED Lighting MODEL SELECTION TABLE Model Number DTSPU131-105 DTSPU131-106 DTSPU131-107 DTSPU131-108 DTSPU131-109 DTSPU131-110 DTSPU131-111 DTSPU131-112 1/5/2016 Input Voltage Range Output Voltage(1) 90~260VAC 12~13VDC 13~16VDC 16~21VDC 21~27VDC 27~33VDC 33~40VDC 40~50VDC 50~55VDC Output Current Min Load Max Load 10A 10.84A 8.12A 10A 6.19A 8.12A 4.81A 6.19A 3.93A 4.81A 3.25A 3.93A 2.60A 3.25A 2.36A 2.60A Ripple & Noise(2) Total Regulation 100 mVp-p ±5% ±5% ±5% ±3% ±3% ±3% ±3% ±3% Output Power 130W No Load Power Consumption Efficiency 0.21W VI V V VI V V V V Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 1 of 4 DTSPU131 SERIES 130 Watts AC/DC Desktop Power Supplies Single Output Rev B SPECIFICATIONS All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. SPECIFICATION TEST CONDITIONS Min Typ Max Unit INPUT SPECIFICATIONS Safety Approval Input Voltage Range Operate Voltage Range Input Voltage Range Input Frequency Low Line Input Current High Line Low Line Input Inrush Current High Line Power Factor Correction OUTPUT SPECIFICATIONS Output Voltage Line Regulation(3) Load Regulation(4) Output Power Output Current Ripple & Noise (Peak to Peak) Transient Response Time Start-Up Time Hold-Up Time(5) Temperature Coefficient PROTECTION Over Voltage Protection Over Load Protection Short Circuit Protection ENVIRONMENTAL SPECIFICATIONS Operating Temperature Storage Temperature Operating Humidity Storage Humidity Surge Voltage Electro Static Discharge Vibration Operating Altitude (Elevation) Cooling Flammability Rating MTBF GENERAL SPECIFICATIONS Efficiency(6) Dielectric Withstanding Voltage Safety Ground Leakage Current PHYSICAL SPECIFICATIONS Weight Full Load, Vin=100VAC Full Load, Vin=240VAC Full Load, 25ºC, Cool Start, Vin=100VAC Full Load, 25ºC, Cool Start, Vin=240VAC Io=Full Load, Vin=240VAC 100 90 47 264 260 63 1.58 0.64 30 50 1 0.95 VAC Hz A A See Table Full load, Vin=100~120VAC Vin=230VAC, 10~90% Load Change at Condition 1 5 3 See Table See Table 100 Full Load, Vin=110VAC Full Load, Vin=100~240VAC Full Load, Vin=100VAC Full Load, Vin=100~240VAC 4 2 16 ±0.04 Recovers Automatically After Fault is Removed Derate linearly from 100% load at 40ºC to 50% load at 70ºC 10~95% RH Non-Condensing mVp-p mS S mS %/ºC 112 110 132 150 Auto Recovery % % 0 -40 0 0 70 85 95 95 2 8 6 5 3000 Free Air Convention UL94V-1 ºC ºC %RH %RH kV All Conditions Air Discharge, IEC61000-4-2 Contact Discharge, IEC61000-4-2 10~500Hz, 10min./1 cycle, 60 min. each along X, Y, Z, axes All Conditions Operating Temperature at 25ºC, Calculated per MIL-HDBK-217F % % 100,000 kV G m Hours See Table Primary to Secondary Primary to Ground Vin=240VAC, Fi=60Hz 4242 2121 VDC 0.75 mA Approx. 27.4~28.2oz (778~800g) 7.44in x 3.52in x 1.79in (188.9mm x 89.5mm x 45.5mm) Dimensions (L x W x H) SAFETY & EMC CHARACTERISTICS Safety Approvals EMC Emission UL/cUL UL60950-1: 2nd Edition TUV/GS (EN 60950-1:2nd Edition) Compliance to EN55022 (CISPR22), EN61000-3-2,-3 Class B NOTES (1) (2) (3) (4) (5) (6) 1/5/2016 Output can provide up to peak load when the power supply starts up. Continuous staying in more than rated load is not allowed. At factory, in 60% rated load condition, each output is checked to be within voltage accuracy. Ripple and Noise is measured by using 20MHz bandwidth limited oscilloscope and terminated each output with a 0.47uF capacitor at rated load and nominal line. Line regulation is defined by changing ±10% of input voltage from nominal line at rated load. Load regulation is defined by changing ±40% of measured output load from 60% rated load. Hold-Up Time is measured from the end of the last charging pulse to the time which the main output drops down to low limit of main output at rated load and nominal line. Efficiency is measured at rated load, and nominal line. Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 2 of 4 Rev B DTSPU131 SERIES 130 Watts AC/DC Desktop Power Supplies Single Output DERATING CURVES Input Voltage Derating Curve Temperature Derating Curve Recommended Output Cable 1. 2. 3. 4. 5. Models DTSPU131-105~106 are required to use AWG#16*5C/4FT output cable in order to meet total regulation specified. Models DTSPU131-107~108 are required to use AWG#16*5C/4FT output cable in order to meet total regulation specified. Models DTSPU131-109~110 are required to use AWG#16*2C/4FT output cable in order to meet total regulation specified. Models DTSPU131-111~112 are required to use AWG#18*2C /4FT output cable in order to meet total regulation specified. The regulation and efficiency will changed if a different output cable is used. MECHANICAL DRAWINGS 1/5/2016 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 3 of 4 Rev B DTSPU131 SERIES 130 Watts AC/DC Desktop Power Supplies Single Output COMPANY INFORMATION Wall Industries, Inc. has created custom and modified units for over 50 years. Our in-house research and development engineers will provide a solution that exceeds your performance requirements on-time and on budget. Our ISO9001-2008 certification is just one example of our commitment to producing a high quality, well-documented product for our customers. Our past projects demonstrate our commitment to you, our customer. Wall Industries, Inc. has a reputation for working closely with its customers to ensure each solution meets or exceeds form, fit and function requirements. We will continue to provide ongoing support for your project above and beyond the design and production phases. Give us a call today to discuss your future projects. Contact Wall Industries for further information: Phone: Toll Free: Fax: E-mail: Web: Address: 1/5/2016 (603)778-2300 (888)597-9255 (603)778-9797 [email protected] www.wallindustries.com 37 Industrial Drive Exeter, NH 03833 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 4 of 4