TF010x Digitally Tunable LC Filters 225 – 520 MHz version – typical performance I. General & Electrical Requirements Tuned Center Frequency Range (FCOM) Note 1: FMIN = 225MHz to FMAX = 520MHz in 250-steps, FSTEP = 1.18MHz 2. Passband @ 3dB: FSIG ±2.5MHz 3. Passband Insertion Loss: ≤ 3.5dB 4. Passband Variation (peak-valley): ≤ 0.3dB 5. Input/Output VSWR (within the FSIG Bandwidth into 50): < 2.0:1 6. Absolute Stop Band Attenuation: FSIG ±10%: 16dB minimum 30MHz to ½ FSIG: 38dB minimum FSIG ±15%: 22dB minimum 2x FSIG to < 750MHz: 35dB minimum FSIG ±20%: 27dB minimum 750MHz to 1.2GHz: 25dB minimum 1.2GHz to 2.0GHz: 15dB minimum 7. IIP3: +45dBm minimum 8. In Band RF Power Handling: ≤ 1.25-watts CW 9. ZIN/ZOUT: 50 nominal 10. Tuning Method: Digital Control: 250-steps, 8-bit parallel Tuning Speed: < 10µsec 11. DC Power: V1: +5VDC ±5% I1: < 275mA V2: 100VDC Note 2 I2: 1.5mA typical 1. Note 1: FSIG = Frequency of the signal, Where; FCOM is the target command frequency that the filter will be directed to. FCOM = Integer((FSIG- FMIN)/ FSTEP)* FSTEP + FMIN Note 2: V2 = 100V, the filter command and tune frequencies are set up with 100V applied and the filter is fully compliant to these specification. For V2 = 50V (I2 = 1ma), the filter will be functional but the filter command frequency may have greater error. Power handling and linearity will be degraded. II. Environmental & Physical Requirements 1. Temperature Range: Operating: -40°C to +85°C Storage: -45°C to +90°C 2. Package Size: 2.300” (L) x 1.100: (W) x 0.600” (H) Style: 42-pin thru-hole Preliminary Typical Performance - Subject to Change Without Notice III. Data Sheet Revision: Date 02/06/13 Rev. - Author BRM Details of Revision Original Draft. Page 1 of 1 MtronPTI - 2525 Shader Road - Orlando - Florida - 32804 - USA - 1-407-298-2000 - www.mtronpti.com The information contained herein is proprietary to MtronPTI and is submitted in confidence. This information may not be copied or divulged without the express written permission of MtronPTI.