Specification for an E-GSM Cavity Duplexer Filter MtronPTI P/N UF9388R I. General & Electrical Requirements: 1. RX Passband: 880MHz - 915MHz Insertion Loss: 0.6dB maximum VSWR: 1.3:1 Maximum Rejection (925MHz to 960MHz): 50dB minimum 2. TX Passband: 925MHz - 960MHz Insertion Loss: 0.8dB maximum VSWR: 1.3:1 Maximum Rejection (880MHz to 915MHz): 50dB minimum Power Handling: 50-watts CW average, 400-watts peak 3. ZIN/ZOUT: 50 nominal (all ports) Note: All specifications are over the full operating temperature Range II. Environmental & Physical Requirements: 1. Environmental Temperature Operating (OTR): -40°C to +85°C Storage (STR): -45°C to +90°C Humidity: Per IEC specification 68-2-30 Shock: 11msec half sine pulse 30G, 3 impacts per axis Transportation Vibration: Per NEBS GR-63 core section 4.4.4 Life Cycle: The target life of the device is 20+ years 2. Package Dimensions (maximum, excluding connectors & assembly and tuning screws): 150mm (L) x 144mm (W) x 60mm (H) I/O Connectors: N-Female (all ports) 3. RoHS Compliance: Full RoHS Compliance Page 1 of 2 The information contained herein is proprietary to MtronPTI and is submitted in confidence. This information may not be copied or divulged without the express written permission of MtronPTI Specification for an E-GSM Cavity Duplexer Filter MtronPTI P/N UF9388R III. Design Simulation Plots IV. Data Sheet Revision Table: Date 03/13/12 03/08/12 Rev. 1 0 Author BRM BRM Details of Revision Corrected a typographical error in the proposed package length. Was 120mm & should have been 150mm. Original Draft. Page 2 of 2 The information contained herein is proprietary to MtronPTI and is submitted in confidence. This information may not be copied or divulged without the express written permission of MtronPTI