Download Datasheet

Specification for a Proposed SMD LC Filter
MtronPTI P/N: LF9437
I. General & Electrical Requirements
1. Center Frequency (FON): 93.75MHz
2. Passband @ 2dB: FON ±15MHz minimum
3. Insertion Loss (@ peak of transmission within the 2dB Passband): < 2.0dB
4. Passband Ripple (peak-valley, excluding the 2dB band edge roll-off): ≤ 0.5dB
5. VSWR: 1.5:1 maximum
6. Rejection (Relative to Insertion Loss):
DC to 62.5MHz: 70dB minimum
125MHz to 620MHz: 70dB minimum
7. ZIN/ZOUT: 50Ω nominal
II. Environmental & Physical Requirements:
1. Temperature Range
Operating: -45C to +85C
Storage: -50C to +90C
2. Solderability: Per EIAJ-STD-002
3. Package (see Figure 1):
Size: 1.500” (L) x 0.400” (W) x 0.250” (H)
Type: SMD (Ref. Figure 1)
Figure 1: Proposed Outline Drawing
Page 1 of 2
The information contained herein is proprietary to MtronPTI and is submitted in confidence.
This information may not be copied or divulged without the express written permission of MtronPTI
Specification for a Proposed SMD LC Filter
MtronPTI P/N: LF9437
III. Design Simulation Plots:
IV. Maximum Solder Reflow Profile:
V. Data Sheet Revision Table:
Date
Rev.
Author
04/18/13
A
BRM
04/09/13
-
BRM
Details of Revision
Corrected a typographical error in the Insertion Loss Specification (should have referenced a 2dB Passband and
not the erroneous 1dB Passband).
Initial Release.
Page 2 of 2
The information contained herein is proprietary to MtronPTI and is submitted in confidence.
This information may not be copied or divulged without the express written permission of MtronPTI