Download

1W DC-DC Converter P1C-Series
●
●
●
●
●
●
●
7 Pin SIL
Low ripple and noise
Isolation 6 kVDC 60 sec. 100% tested
Rated for 250Vrms
MTBF > 2.3 Mhours
Operating temperature range -40...85°C
Efficiency up to 82 %
Model selection guide
Typ
P1C053R3S
P1C0505S
P1C0509S
P1C0512S
P1C0515S
P1C123R3S
P1C1205S
P1C1209S
P1C1212S
P1C1215S
P1C243R3S
P1C2405S
P1C2409S
P1C2412S
P1C2415S
P1C0505D
P1C0509D
P1C0512D
P1C0515D
P1C1205D
P1C1209D
P1C1212D
P1C1215D
P1C2405D
P1C2409D
P1C2412D
P1C2415D
1.
2.
3.
4.
5.
6.
Input nominal
voltage
[VDC]
4.5..5.5
4.5..5.5
4.5..5.5
4.5..5.5
4.5..5.5
10.8..13.2
10.8..13.2
10.8..13.2
10.8..13.2
10.8..13.2
21.6..26.4
21.6..26.4
21.6..26.4
21.6..26.4
21.6..26.4
4.5..5.5
4.5..5.5
4.5..5.5
4.5..5.5
10.8..13.2
10.8..13.2
10.8..13.2
10.8..13.2
21.6..26.4
21.6..26.4
21.6..26.4
21.6..26.4
Output voltage
Output current
[VDC]
3.3
5.0
9.0
12.0
15.0
3.3
5.0
9.0
12.0
15.0
3.3
5.0
9.0
12.0
15.0
±5.0
±9.0
±12.0
±15.0
±5.0
±9.0
±12.0
±15.0
±5.0
±9.0
±12.0
±15.0
Efficiency typ.
[mA]
303
200
111
84
67
303
200
111
84
67
303
200
111
84
67
±100
±56
±42
±34
±100
±56
±42
±34
±100
±56
±42
±34
[%]
69
70
70
70
70
71
74
74
74
74
75
77
80
80
80
70
70
72
70
73
74
75
75
78
80
81
81
Capacitve
load
[µF]
220
220
220
220
220
220
220
220
220
220
220
220
220
220
220
2 x 100
2 x 100
2 x 100
2 x 100
2 x 100
2 x 100
2 x 100
2 x 100
2 x 100
2 x 100
2 x 100
2 x 100
Ripple and Noise measured with 20MHz bandwidth
Tested by minimal Vin and constant resistive load.
Measured Input reflected ripple current with a simulated source inductance of 12µH.
Exceeding the absolute ratings of the unit could cause damage. It is not allowed for continuous operating.
Operation under no-load conditions will not damage these devices, however they may not meet all listed specifications.
For reduce converter’s ripple and noise, it is recommended to add a 4.7..100μF(2 x 4.7..68μF for dual output) capacitor on
output. For EMI performance improvement, it is recommended to add a 12μH inductor and a 10..100μF capacitor in input
end.
Page 1 of 4
Deutschland:
Inselkammerstraße 10
D-82008 Unterhaching
Tel.: 089 614 503-10
E-Mail: [email protected]
Schweiz:
Gründenstrasse 82
CH-8247 Flurlingen
Tel.: 052 647 42 00
E-Mail: [email protected]
1W DC-DC Converter P1C-Series
Specifications
Input
Voltage range
Filter
I/O-Isolation:
DC-Isolation voltage
tested for 60 sec.
Resistance
Capacitance
Output
Voltage accuracy
Voltage balance
(dual outputs)
Ripple and noise
(at 20 MHz BW)
Short circuit protection
Line voltage regulation
@ 1% Vin change
Voltage stability at load
change 20...100%
EMC
EME
ESD
RS
± 10%
Capacitors
6 kV
9
10 Ω, max.
10 pF, typ.
± 3%, max.
± 1%
75 mVp-p, max.
Momentary
± 1.2%
± 10%
± 20% @ 3.3V output
EN 55022 Class B
FCC47 CFR part 15 A
IEC 61000-4-2 / B
IEC 61000-4-3 / A
General
Safety standard
Switching frequency
Environmental
Operating temperature
(ambient)
Case temperature
Storage temperature
Derating
Humidity
Cooling
Physical
Dimensions
Weight
Case material
Capacitive Load:
Single Output
Dual Output
Pin soldering temperature
1.5mm distance from body
IEC 60950-2001
20…50 kHz
-40 °C to +85 °C
100 °C, max.
-40 °C to +125 °C
None required
Up to 95% rel. humidity,
non-condensing
Free-air convection
SIL
19.5x9.8x12.5 mm
4.2 g
non-conductive black plastic
(UL94V-0 rated)
220 µF, max.
100 µF, max.
260°C for 10sec
Dimensions
Pin connections
Pin
1
2
5
6
7
Single
+V Input
-V Input
-V Output
Omitted
+V Output
Dual
+V Input
-V Input
-V Output
Common
+V Output
Life Support Policy: HY-LINE does not authorize the use of any of
its products for use in life support devices or systems without the
express written approval of an officer of the Company. Life support
systems are devices which support or sustain life, and whose failure
to perform, when properly used in accordance with instructions for
use provided in the labeling, can be reasonably expected to result in
significant injury to the user.
Rev: 08.10 f
Page 2 of 2
Deutschland:
Inselkammerstraße 10
D-82008 Unterhaching
Tel.: 089 614 503-10
E-Mail: [email protected]
Schweiz:
Gründenstrasse 82
CH-8247 Flurlingen
Tel.: 052 647 42 00
E-Mail: [email protected]