74LVQ04 Low Voltage Hex Inverter General Description Features The LVQ04 contains six inverters. n Ideal for low power/low noise 3.3V applications n Guaranteed simultaneous switching noise level and dynamic threshold performance n Guaranteed pin-to-pin skew AC performance n Guaranteed incident wave switching into 75Ω Ordering Code: Ordering Number Package Number Package Description 74LVQ04SC M14A 14-Lead (0.150" Wide) Molded Small Outline Package, SOIC JEDEC 74LVQ04SJ M14D 14-Lead Molded Small Outline Package, SOIC EIAJ Devices also available in Tape and Reel. Specify by appending the suffix letter “X” to the ordering code. Logic Symbol Connection Diagram IEEE/IEC Pin Assignment for SOIC JEDEC and EIAJ DS011343-1 DS011343-2 Pin Descriptions Pin Names © 1998 Fairchild Semiconductor Corporation DS011343 Description An Inputs On Outputs www.fairchildsemi.com 74LVQ04 Low Voltage Hex Inverter April 1998 Absolute Maximum Ratings (Note 1) Supply Voltage (VCC) DC Input Diode Current (IIK) VI = −0.5V VI = VCC + 0.5V DC Input Voltage (VI) DC Output Diode Current (IOK) VO = −0.5V VO = VCC + 0.5V DC Output Voltage (VO) DC Output Source or Sink Current (IO) DC VCC or Ground Current (ICC or IGND) Storage Temperature (TSTG) DC Latch-Up Source or Sink Current Recommended Operating Conditions (Note 2) −0.5V to +7.0V Supply Voltage (VCC) Input Voltage (VI) Output Voltage (VO) Operating Temperature (TA) Minimum Input Edge Rate (∆V/∆t) VIN from 0.8V to 2.0V VCC @ 3.0V −20 mA +20 mA −0.5V to VCC + 0.5V −20 mA +20 mA −0.5V to VCC + 0.5V 2.0V to 3.6V 0V to VCC 0V to VCC −40˚C to +85˚C 125 mV/ns Note 1: The “Absolute Maximum Ratings” are those values beyond which the safety of the device cannot be guaranteed. The device should not be operated at these limits. The parametric values defined in the Electrical Characteristics tables are not guaranteed at the absolute maximum ratings. The “Recommended Operating Conditions” table will define the conditions for actual device operation. ± 50 mA ± 200 mA −65˚C to +150˚C Note 2: Unused inputs must be held HIGH or LOW. They may not float. ± 100 mA DC Electrical Characteristics Symbol VIH Parameter Minimum High Level VCC (V) TA = +25˚C Typ 3.0 TA = −40˚C to +85˚C Units 1.5 2.0 2.0 V Maximum Low Level 3.0 1.5 0.8 0.8 V VOUT = 0.1V or VCC − 0.1V Input Voltage VOH VOUT = 0.1V or VCC − 0.1V Input Voltage VIL Conditions Guaranteed Limits 2.9 2.9 V IOUT = −50 µA 2.58 2.48 V VIN = VIL or VIH (Note 3) 0.1 0.1 V IOUT = 50 µA 3.0 0.36 0.44 V VIN = VIL or VIH (Note 3) 3.6 ± 0.1 ± 1.0 µA Minimum High Level 3.0 Output Voltage 3.0 Maximum Low Level 3.0 Output Voltage Maximum Input 2.99 IOH = −12 mA VOL 0.002 IOL = 12 mA IIN VI = VCC, GND Leakage Current IOLD Minimum Dynamic (Note 4) 3.6 36 mA VOLD = 0.8V Max (Note 5) IOHD Output Current 3.6 −25 mA VOHD = 2.0V Min (Note 5) ICC Maximum Quiescent 3.6 20.0 µA VIN = VCC 2.0 Supply Current VOLP Quiet Output or GND 3.3 0.8 1.1 V (Notes 6, 7) 3.3 −0.8 −1.1 V (Notes 6, 7) 3.3 1.7 2.0 V (Notes 6, 8) 3.3 1.6 0.8 V (Notes 6, 8) Maximum Dynamic VOL VOLV Quiet Output Minimum Dynamic VOL VIHD Maximum High Level Dynamic Input Voltage VILD Maximum Low Level Dynamic Input Voltage Note 3: All outputs loaded; thresholds on input associated with output under test. Note 4: Maximum test duration 2.0 ms, one output loaded at a time. Note 5: Incident wave switching on transmission lines with impedances as low as 75Ω for commercial temperature range is guaranteed for 74LVQ. Note 6: Worst case package. Note 7: Max number of outputs defined as (n). Data inputs are driven 0V to 3.3V; one output at GND. Note 8: Max number of Data Inputs (n) switching. (n − 1) inputs switching 0V to 3.3V. Input-under-test switching: 3.3V to threshold (VILD) 0V to threshold (VIHD) f = 1 MHz. www.fairchildsemi.com 2 AC Electrical Characteristics TA = +25˚C Symbol VCC (V) Parameter Min tPLH tPHL Propagation Delay Propagation Delay tOSHL Output to Output Skew (Note 9) tOSLH Data to Output TA = −40˚ C to +85˚C CL = 50 pF CL = 50 pF Typ Max Min Units Max 2.7 1.5 5.4 12.7 1.0 14.0 3.3 ± 0.3 1.5 4.5 9.0 1.0 10.0 2.7 1.5 5.4 12.0 1.0 12.0 3.3 ± 0.3 1.5 4.5 8.5 1.0 9.5 2.7 1.0 1.5 1.5 3.3 ± 0.3 1.0 1.5 1.5 ns ns ns Note 9: Skew is defined as the absolute value of the difference between the actual propagation delay for any two separate outputs of the same device. The specification applies to any outputs switching in the same direction, either HIGH to LOW (tOSHL) or LOW to HIGH (tOSLH). Parameter guaranteed by design. Capacitance Typ Units CIN Symbol Input Capacitance Parameter 4.5 pF VCC = Open Conditions CPD (Note 10) Power Dissipation Capacitance 17 pF VCC = 3.3V Note 10: CPD is measured at 10 MHz. 3 www.fairchildsemi.com 4 Physical Dimensions inches (millimeters) unless otherwise noted 14-Lead (0.150" Wide) Small Outline Package, SOIC JEDEC Package Number M14A 14-Lead Molded Small Outline Package, SOIC EIAJ Package Number M14D 5 www.fairchildsemi.com 74LVQ04 Low Voltage Hex Inverter LIFE SUPPORT POLICY FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 2. A critical component in any component of a life support 1. Life support devices or systems are devices or sysdevice or system whose failure to perform can be reatems which, (a) are intended for surgical implant into sonably expected to cause the failure of the life support the body, or (b) support or sustain life, and (c) whose device or system, or to affect its safety or effectiveness. failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury to the user. Fairchild Semiconductor Corporation Americas Customer Response Center Tel: 1-888-522-5372 www.fairchildsemi.com Fairchild Semiconductor Europe Fax: +49 (0) 1 80-530 85 86 Email: [email protected] Deutsch Tel: +49 (0) 8 141-35-0 English Tel: +44 (0) 1 793-85-68-56 Italy Tel: +39 (0) 2 57 5631 Fairchild Semiconductor Hong Kong Ltd. 13th Floor, Straight Block, Ocean Centre, 5 Canton Rd. Tsimshatsui, Kowloon Hong Kong Tel: +852 2737-7200 Fax: +852 2314-0061 National Semiconductor Japan Ltd. Tel: 81-3-5620-6175 Fax: 81-3-5620-6179 Fairchild does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and Fairchild reserves the right at any time without notice to change said circuitry and specifications.