VECTRON TFS140A1

tfs 140A1.doc
Version 1.4
VI TELEFILTER
Filter Specification
18.07.2000
TFS 140A1 - 1/5
1. Measurement condition
Ambient temperature TA:
Input power level:
Terminating impedances at fc:
23 °C
0 dBm.
for input:
Q-value of matching elements:
for output:
50
448 Ω  - 13,8 pF.
374 Ω  - 14,5 pF.
2. Characteristics
Remark: Reference level for the relative attenuation arel of the TFS 140A1 is the minimum of the pass band attenuation amin. The
minimum of the pass band attenuation amin is defined as the insertion loss ae. The reference frequency fc is the arithmetic mean value of the
upper and lower frequencies at the 3 dB filter attenuation level relative to the insertion loss ae. The temperature coefficient of frequency Tcf is
valid both for the reference frequency fc and the frequency response of the filter in the operating temperature range. The frequency shift of
the filter in the operating temperature range is not included in the production tolerance scheme
Data
typ. value
Insertion loss (Reference level)
18,5...19,0 dB
ae
fc at ambient temperature TA (fCAT)
Centre frequency
tolerance / limit
max.
140,01 MHz
140 ± 0,06 MHz
Pass band at ambient temperature TA:
Amplitude ripple (p-p):
fC
fC - 1,55 MHz.....fC + 1,55 MHz
... fC ± 1,35 MHz
0,5 dB
fC ± 1,35 MHz fC ± 1,42 MHz
Bandwidth
1,0
3
20
40
45
20 dB
0,7 dB
at ambient temperature:
dB - band width
dB - band width
dB - band width
dB - band width
dB - band width
Relative attenuation
fC
fC ± 2,30
fC ± 5,94
2,88
3,15
3,83
4,20
4,24
MHz
MHz
MHz
MHz
MHz
min. 3,10 MHz
max. 4,60 MHz
max.11,88 MHz
arel
............
MHz .....
MHz .....
fC ± 1,55 MHz
fC ± 5,94 MHz
fC ± 40
MHz
Group delay ( mean value in pass band ):
Group delay ripple in pass band (p-p):
Deviation from linear phase in pass band (p-p):
Input VSWR (S11) in PB :
Output VSWR (S22) in PB :
Triple transit attenuation compared to main signal
Crosstalk
Substrate material
Frequency inversion temperature ( To )
Temperature coefficient of frequency ( Tcf )
Frequency deviation of fc over temperature: * )
45...55 dB
60....70 dB
max.
min.
min.
2,49 µs
140...170 ns
5...6 ° (r.m.s. 1,4°)
1,3 : 1
1,4 : 1
41...42 dB
52...55 dB
3 dB
40 dB
45 dB
max. 2,5 µs
max. 200 ns
max. 10°
max. 2 : 1
max. 2 : 1
min. 40 dB
Quartz
25° C
-0,045
ppm/K²
∆fc(Hz) = Tcf(ppm/K) x (T - To)² x fTo (MHz)
Operating temperature range
Storage temperature range
0 °C ... + 70 °C
- 40 °C ... + 85 °C
* ) fTo is reference frequence fc at frequency inversion temperature (To )
Generated:
Dunzow W.P.
Checked/Approved:
Dr. Bert Wall
VI TELEFILTER
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
Vectron International, Inc.
267 Lowell Road
Hudson, NH 03051 / USA
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed
as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
tfs 140A1.doc
Version 1.4
VI TELEFILTER
Filter Specification
18.07.2000
TFS 140A1 - 2/5
3. Package
Datecode:
K
L
M
.......
TFS
G1
TFS 140
140A1
.
M22
M19
Year+week
1998
1999
2000
Pin 10
Pin 1
Pin 5
Pin 6
Pin 2 - 4, 7 - 9
Input
Input RF Return
Output
Output RF Return
Package Ground
4. 50 Ω matching network ( see Application Note ):
L1
50 Ω
= 188 ± 10 nH
L3 = 120 nH;
R1 = 1,8 kΩ;
10
9
TFS
.
1
VI TELEFILTER
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
2
8
7
6
140A1
M22
3
4
L4 = 120 nH;
50kΩ;
Ω
R2 = 1,8
5
L2
= 165 ± 10 nH
Vectron International, Inc.
267 Lowell Road
Hudson, NH 03051 / USA
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed
as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
tfs 140A1.doc
Version 1.4
VI TELEFILTER
Filter Specification
18.07.2000
TFS 140A1 - 3/5
5. Stability Characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 18 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Damp heat:
(cycle)
25 °C to 55°C / 95% r.H. / 10 cycles
DIN IEC 68 - 2 – 30 Db
4. Resistance to
solder heat (reflow):
max. 2 times reflow process;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
6. Packing
Tape & Reel:
DIN IEC 286 - 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
Real of empty components at start:
Real of empty components at start including leader:
Trailer
2000
min 300 mm
min 500 mm
min 300 mm
EMBOSSED CARRIER TAPE
Tape (all dimensions in mm)
Do
W
Po
Do
E
F
G (min)
P2
P1
D1(min)
Ao
Bo
t
CT
:
:
:
:
:
:
:
:
:
:
:
:
:
32
± 0,3
4
± 0,1
1,5
+ 0,1
1,75 ± 0,1
14,2 ± 0,1
0,6
2
± 0,1
12
± 0,1
2,0
7,1
± 0,1
19,6 ± 0,
0,3
± 0,05
25,5 ± 0,1
Po
P
2
E
A
o
F
D
CT
1
W
Bo
G
P1
COVER TAPE
W 2
Reel (all dimensions in mm):
A
:
W1
W2 (max) :
:
N (min)
:
330
32,4 +2
38,4
100
C
C
:
13 +0,5/-0,2
A
N
W 1
The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape.
The marking of the filters is able to read if the view is directed on the upper side of the carrier tape with the sprocket holes on
the right side of the tape.
VI TELEFILTER
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
Vectron International, Inc.
267 Lowell Road
Hudson, NH 03051 / USA
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed
as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
tfs 140A1.doc
Version 1.4
VI TELEFILTER
Filter Specification
18.07.2000
TFS 140A1 - 4/5
7. Air reflow temperature conditions
1st and 2nd air reflow profile
Name:
Temperature:
Time:
pre-heating periods
150 °C - 170 °C
60 sec. - 90 sec.
main-heating periods
over 200 °C
20 sec. - 25 sec.
peak temperature
255 °C ± 5 °C
Air reflow profile
260
240
220
200
temperature / °C
180
160
140
120
100
80
60
40
20
0
0
20
40
60
80
100
120
140
160
180
200
220
240
time / sec.
Table for temperature vs. time during the air reflow process
Tolerance of temperatures: ± 5 °C
time / sec.
0
10
20
30
40
50
60
70
80
90
100
110
120
130
temperature / °C
23
34
46
60
80
103
121
134
143
150
154
156
158
159
VI TELEFILTER
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
time / sec.
140
150
160
170
180
190
195
200
205
210
215
220
230
240
temperature / °C
160
161
164
170
180
205
230
255
230
205
180
165
140
120
Vectron International, Inc.
267 Lowell Road
Hudson, NH 03051 / USA
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed
as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
tfs 140A1.doc
Version 1.4
VI TELEFILTER
Filter Specification
18.07.2000
TFS 140A1 - 5/5
History
Version
Reason of Changes
Name
Date
1.0
Generate specification according to customer requirements.
Dunzow W.
15.05.2000
1.1
Add theoretical matching network scheme.
Change filter name from TFS 140A11 to TFS 140A1
Change input and output pin positions according to customer requirements.
Dunzow W.
31.05.2000
1.2
Correct errors in matching network scheme.
Dunzow W.
05.06.2000
1.3
Change limit value ILo : from ILo = max. 19 dB to ILo = max. 20 dB
Correct wrong unit for limit value of TTS ( ns → dB ).
Add VSWR according to customer requirement.
Edit typical values after measured.
Edit termination impedances .
Dunzow W.
22.06.2000
Dunzow W.
18.07.2000
1.4
VI TELEFILTER
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
Vectron International, Inc.
267 Lowell Road
Hudson, NH 03051 / USA
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed
as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.