FTR-F4 SERIES POWER RELAY 2 POLE 5A/TV-3 RATED COMPACT TYPE FTR-F4 Series RoHS compliant n FEATURES Small high density type relay 288mm2 save 24% compared to VB l UL/CSA/VDE/SEMKO/CQC approved l Insulation distance: minimum 6 mm between coil and contacts IEC60065 Dielectric strength: 4 KVAV Surge strength: 10 KV l Card separation system for high noise resistance between coil and contacts l RoHS compliant since date code: 0437L2 Please see page 5 for more information l n APPLICATIONS CRT monitor EMI protection Audio system speaker protection l l n ORDERING INFORMATION [Example] FTR-F4 A K 012 T (a) (b) (c) (d) (e) – ** (f ) (a) Series Name FTR-F4: FTR-F4 Series (b) Contact Arrangement A : 2 form A (DPST) (c) Coil Type K : Standard type (530 mW) (d) Nominal Voltage 005 012 : 5 VDC, : 12VDC, (e) Contact material / TV-Rating T : Silver alloy TV-3 (f) Custom Designation Special number for customized products 006 : 6VDC, 024 : 24VDC, 009 : 9VDC 048 : 48VDC Ordering Code: FTR-F4AK012T Actual Marking:F4AK012T FTR-F4 SERIES n COIL DATA CHART Standard type MODEL Nominal voltage Coil resistance (±10%) Operate voltage Release voltage Nominal power FTR-F4AK005T 5 VDC 47 Ω 3.75 VDC 0.25 VDC 530 mW FTR-F4AK006T 6 VDC 68 Ω 4.5 VDC 0.3 VDC 530 mW FTR-F4AK009T 9 VDC 155 Ω 6.75 VDC 0.45 VDC 530 mW FTR-F4AK012T 12 VDC 270 Ω 9.0 VDC 0.6 VDC 530 mW FTR-F4AK024T 24 VDC 1,100 Ω 18.0 VDC 1.2 VDC 530 mW FTR-F4AK048T 48 VDC 4,400 Ω 36.0 VDC 2.4 VDC 530 mW Note: All values in the table are measured at 20°C. n SPECIFICATIONS Item FTR-F4 Contact Arrangement 2 form A (DPST) Material Silver alloy Configuration Single Resistance (initial) Maximum 100 mΩ at 1 A, 6 VDC Rating (resistive) 5A, 250VAC / 30VDC Maximum Carrying Current*1 5A Maximum Switching Rating 1,250 VA / 150W Maximum Switching Voltage 400 VAC / 300VDC Maximum Switching Current 5A Minimum Switching Load*2 100mA 5 VDC Maximum Inrush Current 120VAC, 51A (TV-3) at lamp load Nominal Power (at 20ºC) 530mW Operate Power (at 20ºC) 300mW Operating Temperature -40ºC to +70ºC (no frost) Time Value Operate (at nominal voltage) Maximum 15ms (no bounce) Release (at nominal voltage) Maximum 5ms (no bounce) Life Mechanical 2 x 106 ops minimum Coil Electrical Contact rating 1 x 105 ops min. Lamp load (TV-3) 2.5 x 104 ops min. Other Vibration Resistance Misoperation 10 to 55 Hz, at double amplitude of 1.5mm Endurance 10 to 55Hz, at double amplitude of 1.5mm Shock Resistance Misoperation Weight Endurance 200m/s2 (11±1ms) 1,000m/s2 (6±1ms) Approximately 12g *1 Minimum switching loads mentioned above are reference values. Please perform the confirmation test with the actual load before production since reference values may vary according to switching frequencies, environmental conditions and expected reliability levels. FTR-F4 SERIES n INSULATION Item FTR-F4 Note Resistance (initial) Minimum 1,000 MΩ at 500 VDC Dielectric Strength open contacts 1,000 VAC (50/60 Hz) 1 min. coil and contacts 3,000 VAC (50/60 Hz) 1 min. adjacent contacts 4,000 VAC (50/60 Hz) 1 min. Surge Voltage (coil and contact) 10,000 V 1.2 x 50µs standard wave n SAFETY STANDARDS Type UL Compliance Contact rating UL 508 Flammability: UL 94-V0 (plastics) 5A, 277VAC/30VDC (resistive) 1/6 HP, 125VAC 1/4 HP, 277VAC Pilot duty: C300 TV-3 120VAC E63614 CSA C22.2 No. 14 LR 40304 VDE 0435, 0860 Complies with CQC, SEMKO n CHARACTERISTIC DATA Temperature rise (°C) 12 Operate 8 Release 4 0 0 0.2 0.4 0.6 0.8 1.0 Coil power (W) 10 AC Resistive Contact Current (A) 2 1 0.5 DC Resistive 0.2 10 20 50 100 200 Contact Voltage (V) 5A 60 40 0A 20 0 0.2 0.4 0.6 0.8 1.0 1.2 500 1000 2.0 0A 5A 1.8 1.6 1.4 1.2 ge volta rate Ope t coil o h of 1.0 0.8 age te volt Opera coil l o o c of 0.6 0 Coil power (W) Maximum Switching Power 5 80 Service life (x104 operations) Time (ms) 16 Operating range Coil temperature rise 100 Nominal voltage muitiplying factor Timing 20 20 40 60 80 100 Ambient temperature (°C) Live Curve 200 250VAC/30VDC 100 70 50 250VAC cosφ=0.7 30VACτ=7ms 30 20 10 7 5 250VAC cosφ=0.4 30VDC τ=15ms 3 2 1 0 1 2 3 4 5 Contact load current (A) 6 FTR-F4 SERIES n REFERENCE DATA Distribution of operate and release voltage Operate Release 60 40 20 FTR-F4AK012T n=250 80 Operate Release 60 40 40 50 60 70 80 90 100 0 1 2 3 4 Mechanical life test 0 100 50 20 10 5 A A A Voltage (V) Release A A A FTR-F4AK012T n=20 300 OP/minute A A A A A A 2 10 Initial 20 50 Operation (x104) 100 6 7 8 9 0 10 Operate 6 4 0 100 50 20 10 5 Release X FTR-F4AK012T n=8 10 OP/minute 250VAC, 5 A (resistive) X 2 5 Operation (x104) 6 10 10 12 14 16 18 20 Electrical life test Operate 4 20 10 5 8 Contact resistance (m Ω ) 6 0 100 50 X 1 Initial 4 8 2 X 2 200 2 10 8 2 Contact resistance (m) Voltage (V) 4 2 Contact resistance (m) Operate 6 40 Electrical life test 10 8 5 Time (ms) Nominal voltage multiplying factor (%) 10 60 Voltage (V) 20 30 80 Contact resistance (m) 10 FTR-F4AK012T n=250 20 20 0 Distribution of contact resistance 100 Distribution (%) FTR-F4AK012T n=250 80 Distribution of operate and release time 100 Distribution (%) Distribution (%) 100 Release A A FTR-F4AK012T n=8 10 OP/minute 30VDC, 5 A (resistive) A A 2 1 Initial 2 5 Operation (x104) 10 n DIMENSIONS l Dimensions l PC board mounting hole layout (BOTTOM VIEW) l Schematics (BOTTOM VIEW) FTR-F4 type 12.0+0.3(.472+.012) 24.0 +0.3(.945+.012) 3.3 (.138) ø0.5. (.020) 7.5(.295) (0.5(.020) 1.8(.071) 0.3(.011) 15 (0.590) 3 6 5 4 15(.590) 5(.197) 2-ø0.9(.035) 4-ø1.3(.051) 1.0(.039) 0.4(.016) 5(.197) 2 7.5(.295) 25.0 +0.3(.984+.012) 1.8(.071) 1 7.5(.295) Unit: mm FTR-F4 SERIES RoHS Compliance and Lead Free Relay Information 1. General Information Relays produced after the specific date code that is indicated on each data sheet are lead-free now. All of our signal and power relays are lead-free. Please refer to Lead-Free Status Info. (http://www.fujitsu.com/us/downloads/MICRO/fcai/relays/lead-free-letter.pdf) l Lead free solder paste currently used in relays is Sn-3.0Ag-0.5Cu. l All signal and power relays also comply with RoHS. Please refer to individual data sheets. Relays that are RoHS compliant do not contain the 5 hazardous materials that are restricted by RoHS directive (lead, mercury, chromium IV, PBB, PBDE). l It has been verified that using lead-free relays in leaded assembly process will not cause any problems (compatible). l “LF” is marked on each outer and inner carton. (No marking on individual relays). l To avoid leaded relays (for lead-free sample, etc.) please consult with area sales office. l We will ship leaded relays as long as the leaded relay inventory exists. Note: Cadmium was exempted from RoHS on October 21, 2005. (Amendment to Directive 2002/95/EC) l 2. Recommended Lead Free Solder Profile l Recommended solder paste Sn-3.0Ag-0.5Cu. Reflow Solder condition Flow Solder condition: Pre-heating: Soldering: maximum 120˚C dip within 5 sec. at 260˚C soler bath Solder by Soldering Iron: Soldering Iron Temperature: maximum 360˚C Duration: maximum 3 sec. We highly recommend that you confirm your actual solder conditions 3. Moisture Sensitivity l Moisture Sensitivity Level standard is not applicable to electromechanical realys. 4. Tin Whisker l Dipped SnAgCu solder is known as low risk tin whisker. No considerable length whisker was found by our in house test. FTR-F4 SERIES Fujitsu Components International Headquarter Offices Japan Fujitsu Component Limited Gotanda-Chuo Building 3-5, Higashigotanda 2-chome, Shinagawa-ku Tokyo 141, Japan Tel: (81-3) 5449-7010 Fax: (81-3) 5449-2626 Email: [email protected] Web: www.fcl.fujitsu.com Europe Fujitsu Components Europe B.V. Diamantlaan 25 2132 WV Hoofddorp Netherlands Tel: (31-23) 5560910 Fax: (31-23) 5560950 Email: [email protected] Web: emea.fujitsu.com/components/ North and South America Fujitsu Components America, Inc. 250 E. Caribbean Drive Sunnyvale, CA 94089 U.S.A. Tel: (1-408) 745-4900 Fax: (1-408) 745-4970 Email: [email protected] Web: http://www.fujitsu.com/us/services/edevices/components/ Asia Pacific Fujitsu Components Asia Ltd. 102E Pasir Panjang Road #01-01 Citilink Warehouse Complex Singapore 118529 Tel: (65) 6375-8560 Fax: (65) 6273-3021 Email: [email protected] Web: http://www.fujitsu.com/sg/services/micro/components/ ©2007 Fujitsu Components America, Inc. All rights reserved. All trademarks or registered trademarks are the property of their respective owners. Fujitsu Components America or its affiliates do not warrant that the content of datasheet is error free. In a continuing effort to improve our products Fujitsu Components America, Inc. or its affiliates reserve the right to change specifications/datasheets without prior notice. Rev. November 30, 2007