MINIATURE RELAY 1 POLE—1 to 2 A (FOR SIGNAL SWITCHING) MZ SERIES RoHS compliant n FEATURES Subminiature size lStandard and high sensitivity types available lUL, CSA recognized lFCC rules and regulations part 68 —Dielectric strength 1,500 V between coil and contacts lHigh reliability-bifurcated contacts available lDIL pitch terminals lPlastic sealed type lRoHS compliant since date code: 0437L2 Please see page 6 for more information l n ORDERING INFORMATION [Example] MZ F – 12 W HG – K – U (a) (b) (c) (d) (e) (f ) (g) (a) Series Name (b) Dielectric Function MZ: MZ Series (c) Refer to the COIL DATA CHART Nominal Voltage Nil : Standard type F : High dielectric strength type (d) Contact Nil : 1 A single D : 2 A single (without MZF) W : 1 A bifurcated type (e) Coil Type HG: Standard type (without MZ-D) (450-500mW) HS : High sensitivity type (without MZF/MZ-D) (190-270mW) (f ) Enclosure Nil : Flux free type K : Plastic sealed type (g) UL, CSA Standard Nil : Non UL, • CSA approved type U : UL • CSA approved type Note: For movable and stationary contact with gold overlay type, add suffix “–OH”. 1 MZ SERIES n COIL DATA CHART MODEL Coil Nominal Single Bifurcated resistance voltage (±10%) 2 A Type 1 A Type 1 A Type Must operate voltage Must release voltage Nominal power MZ-1.5D-(K) MZ (F)-1.5HG-(K) MZ-1.5WHG-(K) 1.5 VDC 5 Ω 1.05 VDC 0.08 VDC 450 mW MZ- 3 D-(K) MZ (F)- 3 HG-(K) MZ- 3 WHG-(K) 3 VDC 20 Ω 2.1 VDC 0.15 VDC 450 mW MZ-4.5D-(K) MZ (F)-4.5HG-(K) MZ-4.5WHG-(K) 4.5 VDC 45 Ω 3.15 VDC 0.23 VDC 450 mW MZ- 5 D-(K) MZ (F)- 5 HG-(K) MZ- 5 WHG-(K) 5 VDC 56 Ω 3.5 VDC 0.25 VDC 450 mW MZ- 6 D-(K) MZ (F)- 6 HG-(K) MZ- 6 WHG-(K) 6 VDC 80 Ω 4.2 VDC 0.3 VDC 450 mW MZ- 9 D-(K) MZ (F)- 9 HG-(K) MZ- 9 WHG-(K) 9 VDC 180 Ω 6.3 VDC 0.45 VDC 450 mW MZ-12 D-(K) MZ (F)-12 HG-(K) MZ-12 WHG-(K) 12 VDC 320 Ω 8.4 VDC 0.6 VDC 450 mW MZ-18 D-(K) MZ (F)-18 HG-(K) MZ-18 WHG-(K) 18 VDC 720 Ω 12.6 VDC 0.9 VDC 450 mW MZ-24 D-(K) MZ (F)-24 HG-(K) MZ-24 WHG-(K) 24 VDC 1,280 Ω 16.8 VDC 1.2 VDC 450 mW MZ-48 D-(K) MZ (F)-48 HG-(K) MZ-48 WHG-(K) 48 VDC 4,600 Ω 33.6 VDC 2.4 VDC 500 mW MZ-1.5HS-(K) MZ-1.5WHS-(K) 1.5 VDC 12 Ω 1.05 VDC 0.08 VDC 190 mW MZ- 3 HS-(K) MZ- 3 WHS-(K) 3 VDC 45 Ω 2.1 VDC 0.15 VDC 200 mW MZ-4.5HS-(K) MZ-4.5WHS-(K) 4.5 VDC 100 Ω 3.15 VDC 0.23 VDC 200 mW MZ- 5 HS-(K) MZ- 5 WHS-(K) 5 VDC 120 Ω 3.5 VDC 0.25 VDC 200 mW MZ- 6 HS-(K) MZ- 6 WHS-(K) 6 VDC 180 Ω 4.2 VDC 0.3 VDC 200 mW MZ- 9 HS-(K) MZ- 9 WHS-(K) 9 VDC 400 Ω 6.3 VDC 0.45 VDC 200 mW MZ-12 HS-(K) MZ-12 WHS-(K) 12 VDC 700 Ω 8.4 VDC 0.6 VDC 200 mW MZ-15 HS-(K) MZ-15 WHS-(K) 15 VDC 1,100 Ω 10.5 VDC 0.75 VDC 200 mW MZ-18 HS-(K) MZ-18 WHS-(K) 18 VDC 1,600 Ω 12.6 VDC 0.9 VDC 200 mW MZ-24 HS-(K) MZ-24 WHS-(K) 24 VDC 2,800 Ω 16.8 VDC 1.2 VDC 200 mW MZ-48 HS-(K) MZ-48 WHS-(K) 48 VDC 8,500 Ω 33.6 VDC 2.4 VDC 270 mW High Sensitivity Type Standard Type Note: All values in the table are measured at 20°C. MZ SERIES n SPECIFICATIONS Standard Single High Sensitivity Type Item Contact Arrangement 1 form C (SPDT) Material Gold-overlay Gold overlay silver-palladium silver-nickel Resistance (initial) Maximum 100 mΩ (at 1 A 6 VDC) Rating (resistive) 2 A 24 VDC 1 A 120 VAC Maximum Carrying Current 2A Maximum Switching Power 120 VA/48 W Maximum Switching Voltage 120 VAC, 60 VDC Maximum Switching Current 2 A Minimum Switching Load* 1 mA 1 VDC Capacitance (at 10 MHz) Approximately 0.8 pF (between open contacts, adjacent contacts) Approximately 7.5 pF (between coil and contacts) Coil Nominal Power (at 20°C) 450 to 500 mW 190 to 270 mW Operate Power (at 20°C) 220 to 250 mW 100 to 130 mW Operating Temperature –30°C to +55°C (no frost) – 30°C to +75°C Time Value Operate (at nominal voltage) Maximum 6 ms Release (at nominal voltage) Maximum 3 ms Life Mechanical 2 × 107 operations minimum MZ-( ) D Bifurcated Single MZ-( ) HG MZ-( ) WHG Bifurcated MZ-( ) HS MZ-( ) WHS 1 A 24 VDC 0.5 A 120 VAC 60 AV/24 W 1A 0.1 mA 100 mVDC 1 mA 1 VDC 0.1 mA 100 mVDC Electrical (at rating) 1 A 120 VAC 0.5 A 120 VAC 2 × 105 operations minimum 1 × 105 ops. min. 1 A 24 VAC 5 × 105 operations minimum 2 A 24 VDC 2 × 105 ops. min. Other 10 to 55 Hz (double amplitude of 3.28 mm) Vibration Misoperation Resistance Endurance Shock Misoperation Resistance Endurance 100 m/s2 (11±1 ms) Weight Approximately 3.5 g 10 to 55 Hz (double amplitude of 3.28 mm) 1,000 m/s2 ( 6±1 ms) *1 Minimum switching loads mentioned above are reference values. Please perform the confirmation test with the actual load before production since reference values may vary according to switching frequencies, environmental conditions and expected reliability levels. MZ SERIES n INSULATION Item Single Isolation (initial) Minimum 100 MΩ (at 500VDC) Dielectric Strength open contacts Standard: 500VAC 1 min., High isolation: 1,000VAC 1 min. coil and contacts Standard: 500VAC 1 min., High isolation: 1,500VAC 1 min. Surge Voltage 1500V (coil-contact) (1/40 µs standard wave) n SAFETY STANDARDS AND FILE NUMBERS Type Compliance Contact rating UL UL 508 UL 60950-1 E 45026 CSA C22.2 No. 14 LR 35579 Flammability: UL 94-V0 (plastics) [1A] 0.5A, 120VAC (resistive) 1A, 24VDC (resistive) [2A] 1A, 120VAC (resistive) 2A, 30VDC (resistive) n CHARACTERISTIC DATA 0.1 0.3 0.5 MZ SERIES n REFERENCE DATA MZ SERIES n DIMENSIONS l Dimensions MZ (F) type (Flux free type) l Schematics (Bottom View) PC board mounting hole layout (Bottom View) l MZ (F)-K type (Plastic sealed type) Unit: mm MZ SERIES RoHS Compliance and Lead Free Relay Information 1. General Information Relays produced after the specific date code that is indicated on each data sheet are lead-free now. Most of our signal and power relays are lead-free. Please refer to Lead-Free Status Info. (http://www.fujitsu.com/us/downloads/MICRO/fcai/relays/lead-free-letter.pdf) l Lead free solder paste currently used in relays is Sn-3.0Ag-0.5Cu. l All signal and most power relays also comply with RoHS. Please refer to individual data sheets. Relays that are RoHS compliant do not contain the 5 hazardous materials that are restricted by RoHS directive (lead, mercury, chromium IV, PBB, PBDE). l It has been verified that using lead-free relays in leaded assembly process will not cause any problems (compatible). l “LF” is marked on each outer and inner carton. (No marking on individual relays). l To avoid leaded relays (for lead-free sample, etc.) please consult with area sales office. l We will ship leaded relays as long as the leaded relay inventory exists. Note: Cadmium was exempted from RoHS on October 21, 2005. (Amendment to Directive 2002/95/EC) l 2. Recommended Lead Free Solder Profile l Recommended solder paste Sn-3.0Ag-0.5Cu. Reflow Solder condition Flow Solder condition: Pre-heating: Soldering: maximum 120˚C dip within 5 sec. at 260˚C soler bath Solder by Soldering Iron: Soldering Iron Temperature: maximum 360˚C Duration: maximum 3 sec. We highly recommend that you confirm your actual solder conditions 3. Moisture Sensitivity l Moisture Sensitivity Level standard is not applicable to electromechanical realys. 4. Tin Whisker l Dipped SnAgCu solder is known as low risk tin whisker. No considerable length whisker was found by our in house test. MZ SERIES Fujitsu Components International Headquarter Offices Japan Fujitsu Component Limited Gotanda-Chuo Building 3-5, Higashigotanda 2-chome, Shinagawa-ku Tokyo 141, Japan Tel: (81-3) 5449-7010 Fax: (81-3) 5449-2626 Email: [email protected] Web: www.fcl.fujitsu.com Europe Fujitsu Components Europe B.V. Diamantlaan 25 2132 WV Hoofddorp Netherlands Tel: (31-23) 5560910 Fax: (31-23) 5560950 Email: [email protected] Web: emea.fujitsu.com/components/ North and South America Fujitsu Components America, Inc. 250 E. Caribbean Drive Sunnyvale, CA 94089 U.S.A. Tel: (1-408) 745-4900 Fax: (1-408) 745-4970 Email: [email protected] Web: http://www.fujitsu.com/us/services/edevices/components/ Asia Pacific Fujitsu Components Asia Ltd. 102E Pasir Panjang Road #01-01 Citilink Warehouse Complex Singapore 118529 Tel: (65) 6375-8560 Fax: (65) 6273-3021 Email: [email protected] Web: http://www.fujitsu.com/sg/services/micro/components/ ©2008 Fujitsu Components America, Inc. All rights reserved. All trademarks or registered trademarks are the property of their respective owners. Fujitsu Components America or its affiliates do not warrant that the content of datasheet is error free. In a continuing effort to improve our products Fujitsu Components America, Inc. or its affiliates reserve the right to change specifications/datasheets without prior notice. Rev. January 9, 2008.