Filename: tfs 309a.doc Version 1.2 VI TELEFILTER 08.11.2007 Filter specification TFS 309A 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: 23 0 °C dBm 731,5 Ω || -4,5 pF 809,5 Ω || -3,8 pF Characteristics Remark: The reference level for the relative attenuation arel of the TFS 309A is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 309,4 MHz without any tolerance. The given values for both the relative attenuation arel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc. Data typ. value Insertion loss (reference level) ae Nominal frequency fN - Centre frequency fC 309,4 PB Passband Pass band ripple fN ± ± ± ± 0,75 1,5 3,0 21,4 50,0 MHz MHz MHz MHz MHz dB max. 7,6 309,4 MHz dB MHz - - fN 0 dB max. 0,40 ± 0,25 MHz 0,5 dB arel Relative attenuation fN fN fN fN fN 5,3 tolerance / limit … fN ± 0,25 MHz … fN … fN … fN ± ± ± 1,5 3,0 4,5 MHz MHz MHz … fN ± 300,0 MHz Group delay ripple within PB IIP3 ** OTR Storage temperature range Frequency inversion temperature Temperature coefficient of frequency max. dB dB dB dB dB min. min. min. min. min. 10 40 50 60 50 dB dB dB dB dB 166 ns max. 500 ns dBm min. 30 dBm max. 15 dBm 33 - Input power level Operating temperature range dB 13 46 53 64 57 TCf *** 0,5 - - 40 °C ... + 85°C - - 55 °C ... +105°C 23 °C -0,043 ppm/K dB 2 *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) fin1= 309,35 MHz; fin2= 309,3 MHz; Pin= -10 dBm fmeasurement = 309,4 MHz and fin1= 309,45 MHz; fin2= 304,5 MHz; Pin= - 10 dBm fmeasurement = 309,4 MHz. ***) ∆f(Hz) = TCf(ppm/K²) x (T-T0)² x fTo(MHz) Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 309a.doc Version 1.2 VI TELEFILTER 08.11.2007 Filter specification TFS 309A 2/5 0 4.18 -1 3.82 -20 -2 3.46 -30 -3 3.1 -4 2.74 -5 2.38 -6 2.02 -70 -7 1.66 -80 -8 1.3 -90 -9 0.94 -40 -50 -60 -100 269.4 277.4 285.4 293.4 301.4 309.4 317.4 frequency in MHz 325.4 333.4 341.4 349.4 -10 308.65 308.8 308.95 309.1 309.25 309.4 309.55 309.7 309.85 frequency in MHz 310 delay in µs 0 -10 magnitude in dB magnitude in dB Filter characteristic 0.58 310.15 Construction and pin connection (All dimensions in mm) S 309A ● U51 3 Date code 2 Max. 1 Input Input RF Return Ground Ground Ground Ground Output Output RF Return Ground Ground Ground Ground Date code: U V W ... Year + week 2006 2007 2008 1 5,2 Max. 2,54 ±0,2 7,2 Max. 2,54 ±0,2 1 1 2 3 4 5 6 7 8 9 10 11 12 0,80 50 Ω Test circuit L1 1 2 7 SAW L2 8 C2 C1 3, 4, 5, 6, 9, 10, 11, 12 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 309a.doc Version 1.2 VI TELEFILTER 08.11.2007 Filter specification TFS 309A 3/5 Stability characteristics, reliability After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: three times max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 – 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer: 3000 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction Tape (all dimensions in mm) W : 16,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,1 F : 7,50 ± 0,1 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 8,00 ± 0,1 D1(min) : 1,50 Ao : 5,50 ± 0,1 Bo : 7,50 ± 0,1 Ct : 13,5 ± 0,1 P1 Date Code Do P2 W G Ct Bo F G E t Po Ko Typ PIN Marker D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 16,4 +2/-0 W2(max) : 22,4 N(min) : 50 C : 13,0 +0,5/-0,2 A C N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 309a.doc Version 1.2 VI TELEFILTER 08.11.2007 Filter specification TFS 309A 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 309a.doc VI TELEFILTER Version 1.2 Filter specification 08.11.2007 TFS 309A 5/5 History Version Reason of Changes Name Date 1.0 - Generation of development specification Strehl 20.02.2006 1.1 - Change input power level and storage temperature range Strehl 23.03.2006 1.2 - Change from development specification to filter specification - Change Intermodulation value - Add terminating impedance value - Add typical values - Add filter characteristics - Add matching circuit Alawneh 08.11.2007 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.