ST Sitronix ST8016 160 Output LCD Common/Segment driver IC PRELIMINARY Notice: This is not a final specification. Some parameters are subject to change 1. DESCRIPTION y Line latch circuits are reset when DISPOFF active The ST8016 is a 160-output segment/common driver IC suitable for driving large/medium scale dot matrix (Common mode) LCD panels, and is used in personal computers/work y Shift clock frequency: 4 MHz (MAX.) stations. Through the use of SST (Super Slim TCP) y Built-in 160-bit bi-directional shift register (divisible technology, it is ideal for substantially decreasing the size of the frame section of the LCD module. The ST8016 is good both as a segment driver and a into 80 bits x 2) y Available in a single mode (160-bit shift register) or in a dual mode (80-bit shift register x 2) common driver, and it can create a low power ¾ Y1->Y160 Single mode consuming, high-resolution LCD. ¾ Y160->Y1 Single mode 2. FEATURES ¾ Y1->Y80, Y81->Y160 Dual mode ¾ Y160->Y81, Y80->Y1 Dual mode y Number of LCD drive outputs: 160 The above 4 shift directions are pin-selectable y Supply voltage for LCD drive: +15.0 to +40.0 V y Shift register circuits are reset when DISPOFF active y Supply voltage for the logic system: +2.5 to +5.5 V y Low power consumption y Low output impedance Package: 186-pin TCP (Tape Carrier Package) 3. PIN CONNECTIONS 186 PIN TCP Y1 1 Y2 Y3 186 (Segment mode) y Shift clock frequency - 20 MHz (MAX.): VDD = +5.0 ± 0.5 V CHIP SURFACE - 15 MHz (MAX.): VDD = +3.0 to + 4.5 V - 12 MHz (MAX.): VDD = +2.5 to + 3.0 V y Adopts a data bus system y 4-bit/8-bit parallel input modes are selectable with a mode (MD) pin y Automatic transfer function of an enable signal y Automatic counting function which, in the chip selection mode, causes the internal clock to be 161 V0R V12R V43R VSS MD FR EIO1 LP DISPOFF XCK DI7 DI6 DI5 DI4 DI3 DI2 DI1 DI0 EIO2 S/C VDD L/R VSS V43L V12L V0L Y158 Y159 Y160 160 stopped by automatically counting 160 bits of input data V0.32 2001-Aug-29