Oscilent Corporation IF SAW Filter | 815-IF43.5M-C Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 815-IF43.5M-C 15.9 x 5.9 Thru Hole Digital A/V & Broadcasting June 17 2003 . TYPE : 43.5 MHz Vestigial Sideband Filter PART NUMBER : 815-IF43.5M-C . Horizontal : 1.5 MHz/Div Veritical : 10 dB/Div Horizontal : 0.6 MHz/Div Veritical : 1 dB/Div Veritical : 100 ns/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Reference Level Frequency - - 43.5 - MHz Insertion Loss - - 23.5 26 dB -1.3 -0.3 0.7 Picture Carrier (46.50 MHz) 0.6 1.4 2.6 Sound Carrier (41.25 MHz) -1.2 0.4 0.8 Adjacent Picture Carrier (39.75 MHz) 30.0 38.0 - Adjacent Sound Carrier (47.25 MHz) 30.0 38.0 - Lower Sidelobe (35.0 ~ 39.25 MHz) 30.0 36.0 - Upper Sidelobe (47.75 ~ 55.0 MHz) 30.0 31.5 - 40 48 - - - 43 - - - 80 - nsec - -72 - ppm/K Relative Attenutation Picture Carrier (45.75 Mhz) Reflected Wave Signal Suppression 2.0 ~ 6.0 us after main Feedthrough Signal Suppression 1.3 ~ 1.2 us before main Group Delay Variation Temperature Coefficient of Freq (TCf) dB * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE http://www.oscilent.com/spec_pages/if_sawfilter/if_815_if43_5c.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 815-IF43.5M-C Page 2 of 2 Source Impedance = 50 ohms Load Impedance = 50 ohms Part No.: 815-IF43.5M-C Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_815_if43_5c.htm 12/28/2005