SPECIFICATION CONTROL DRAWING MATERIALS 1. INSULATION SLEEVE: Heat-shrinkable, transparent blue, radiation cross-linked modified polyvinylidene fluoride. 2. INTEGRAL THREE-HOLE INSERT: Low outgassing immersion resistant thermoplastic, color-natural. 3. SEPARATE THREE-HOLE INSERT: Low outgassing immersion resistant thermoplastic, color-natural. 4. CRIMP SPLICER: Base Metal: Copper Alloy 101 or 102 per ASTM B-75. Plating: Tin per MIL-T-10727, Type 1. APPLICATION 1. This assembly is designed to provide immersion resistant 2 or 3 to 1 in-line splices wires having a total CMA per side between 304 and 1510 and insulations rated for at least 135°C. 2. For requirements and assembly instructions, see Raychem Devices Specification Control Drawing D-436-42/-43. Tyco Electronics Corporation 305 Constitution Drive Menlo Park, CA 94025, USA UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS. INCHES DIMENSIONS ARE BETWEEN BRACKETS. TOLERANCES: 0.00 N/A 0.0 N/A 0 N/A ANGLES: N/A ROUGHNESS IN MICRON DRAWN BY: M. FORONDA Tyco Electronics reserves the right to amend this drawing at any time. Users should evaluate the suitability of the product for their application. REPLACES: N/A DCR NUMBER: D001275 If this document is printed it becomes uncontrolled. Check for the latest revision. Raychem Products DOCUMENT NO.: TITLE : IN-LINE SPLICE SEALING SYSTEM, 2 OR 3 TO 1 D-436-0115 DATE: DOC ISSUE: 1 14-Nov.-00 PROD. REV. A SCALE: None SIZE: A SHEET: 1 of 1