BPW-7010 100W AC-DC Open Frame Power Supply 1 7.0 6.02 TRANSFORMER TB1 L H E 19.0 AC-DC 0.21 max. 3.8 max. 0.5 TB2 Features Industrial Power Supply 20.0 Safety Standards *Safety: UL 1950 / CSA 22.2 No.234 / VDE EN60950 *Input Voltage: 85~264VAC *EMI: FCC class B / EN55022 B *Input Frequency: 47~63Hz *EMS: Level 3 of IEC-802, 803, 804, 805 *Input Current: 3A at 115VAC or 1.5A at 230VAC *Inrush Current: < 30A at 115VAC input or < 60A at 230VAC input, under 24oC cold start *Load Range: With all output at 60% rated load, +5V is Output PIN between 4.95V and 5.05V. All other outputs are within the +5V 1~3 accuracy range. Effective so long as the max. load does not GND 4~7 exceed 90W continuous convection cooling +12V 8~9 -12V 10 *Ripple and Noise: Peak to peak ripple and noise for each +24V 11 output is < 1% of each output's voltage at rated load 12 N/C *Line Regulation: < +/-1% for rated load with +/-10% change in input voltage Output Min. Rated Max. Voltage *Load Regulation: < +/-1% for +5V and < +/-5% for all Voltage Load Load Load Accuracy other outputs +5V 1A 10A 12A 4.9~5.1V *Hold Up Time: > 16ms at 115VAC input and rated load +12V 0A 2.5A 5A 11.25~12.75V *Efficiency: > 70% measured at nominal line and rated load -12V 0A 0.5A 1A -11.25~-12.75V *Altitude: > 10,000 feet +24V 0A 0.5A 1A 22.8~25.2V *Protection: Built-in crowbar circuit. Trip point is between 5.7~7V. AC line off and on cycle for over voltage recovery and restart hiccup mode protection against short circuit or over load condition *Temperature: 0~+50oC forced air 30CFM needed when output > 80W (operating); -40~+85oC (storage) *Connectors: AC Input: Molex 5273-05A withdraw 2-pin or equivalent device DC Output: Molex 5273-12A or equivalent device *Dimensions: 7.0 x 20.0 x 3.8 cm at tolerance +/-0.4mm www.boser.com.tw