THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D AT A SHEET CRYSTAL CONTROLLED OSCILLATORS CW 0611 FPLD54TE1G5 622.08M 3.3V SURFACE MOUNT CLOCK OSCILLATOR ABSOLU TE MAX IMUM RATING S PARAMETER UNITS MINIMUM NOMINAL MAXIMUM UNITS -40 - 85 °C Storage Temperature Supply Voltage (Vcc) -0.5 - 7.0 Vdc Control Voltage (Vc) -0.5 - 7.0 Vdc OPERATING SPECIFIC ATIONS NOTE DESCRIPTION TABLE 2.0 PARAMETER MINIMUM Center Frequency (Fo) Total Frequency Tolerance Operating Temperature Range MAXIMUM UNITS - NOMINAL 622.08000 644.53125 666.51430 669.32660 672.16270 - MHz -20 - 20 ppm 0 - 70 °C Vdc NOTE 1 Supply Voltage (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - - 100 mA Jitter (BW=10Hz to 20MHz) - - 5 ps rms Jitter (BW=12kHz to 80MHz) - - 1 ps rms SSB Phase Noise at 100Hz offset - -60 - dBc/Hz SSB Phase Noise at 1KHz offset - -90 - dBc/Hz SSB Phase Noise at 10KHz offset - -130 - dBc/Hz SSB Phase Noise at 100KHz offset - -135 - dBc/Hz MINIMUM NOMINAL MAXIMUM UNITS NOTE - 1.68 Vdc 2 - Vdc 2 INPUT CHARACTERISTICS TABLE 3.0 PARAMETER Enable Input Voltage (Low) (Default) (Vil) - Disable Input Voltage (High) (Vih) 2.275 PARAMETER NOMINAL MAXIMUM UNITS NOTE - - 50 Ohms 3 (High) (Voh) 2.275 - - Vdc (Low) (Vol) - - 1.68 Vdc 45 50 55 % - - 1 nS Duty Cycle at 50% Level Rise / Fall Time 20% to 80% FEATURES LOW PROFILE, SURFACE MOUNT PACKAGE TABLE 4.0 MINIMUM LOAD The Connor-Winfield FPLD54TE1G5 is a 3.3V Clock Oscillator with Differential LVPECL outputs and Enable/Disable function. The FPLD54TE1G5 is designed for use with PLL systems in SONET/SDH systems requiring low jitter and tight stability. No multiplication schemes are used in this oscillator design. 3.3V OPERATION LOW VOLTAGE PECL OUTPUT CHARACTERISTICS Voltage FPLD54TE1G5 TABLE 1.0 LOW JITTER <1pS RMS TOTAL FREQUENCY TOLERANCE: ±20ppm TEMPERATURE RANGE: 0 to 70°C DIFFERENTIAL LVPECL OUTPUTS PACKAG E CHARACTERISTICS Package TABLE 5.0 Non-hermetic package consisting of an FR4 substrate with grounded metal cover. ENABLE / DISABLE FUNCTION TAPE AND REEL PACKAGING PROCESS RECOMMENDATIONS TABLE 6.0 Soldering Process Wash Notes 1.0 2.0 3.0 RoHS 5/6 COMPLIANT See solder profile on page 2. Ultrasonic cleaning is not recommended. ORDERING INFORMATION Inclusive of calibration @ 25°C, frequency stability vs. temperature, supply and load variations, shock, vibration and aging for twenty years. Control voltage (Vc) = 1.65 Vdc. When oscillator is disabled the true output is in a low state (Vol) and the complementary output is in the high state (VoH). Outputs are enabled with no connection on enable pad. 50 ohm termination into Vcc-2V or Thevein equivalent. FPLD54TE1G5 - 622.08MHz LVPECL CLOCK SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Ec229 PAGE 1 OF 2 REV: 02 DATE: 10/27/06 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D AT A SHEET CRYSTAL CONTROLLED OSCILLATORS Pin Connections Package Outline .140 MAX (3.56mm) CW FPLD54TE1G5 622.08M N/C ENABLE / DISABLE Dimensional Tolerance: ±.005 (.127mm) Output Waveform Suggested Pad Layout Test Circuit Solder Profile Temperature 225°C Ramp-Up Rate 3°C/second max. from 150°C to 225°C. 225°C tp Ramp-Down Rate 6°C/second max. 183°C 150°C 100°C 2 25°C N/C 0 E/D Time 60-120s Max. 10-30s 60-150s Max. 360 Sec. Max. Specifications subject to change without notice. DATA SHEET #: Ec229 PAGE 2 OF 2 REV: 02 DATE: 10/27/06 aCopyright 2001 Connor-Winfield all rights reserved.