HUASHAN HCP12C60

Shantou Huashan Electronic Devices Co.,Ltd.
HCP12C60
Silicon Controlled Rectifier
█ Features
* Repetitive Peak Off-State Voltage : 600V
* R.M.S On-State Current(IT(RMS)=12A)
* Low On-State Voltage (1.3V(Typ.)@ ITM)
* Non-isolated Type
█ General Description
Standard gate triggering SCR is suitable for the application where
requiring high bi-directional blocking voltage capability and also
suitable for over voltage protection,motor control cicuit in power
tool,inrush current limit circuit and heating control system.
█ Absolute Maximum Ratings(Ta=25℃ unless otherwise specified)
T s t g ——Storage Temperature ------------------------------------------------------ -40~125℃
T j ——Operating Junction Temperature ---------------------------------------------- -40~125℃
VDRM ——Repetitive Peak Off-State Voltage -------------------------------------------------------------------- 600V
IT(RMS)——R.M.S On-State Current(180º Conduction Angles)---------------------------------------- 12A
IT(AV) ——Average On-State Current (Half Sine Wave : TC = 109 °C) ----------------------------------------7.6A
ITSM ——Surge On-State Current (1/2 Cycle, 60Hz, Sine Wave, Non-repetitive) -------------------------- 132A
I2t ——Circuit Fusing Considerations(t = 8.3ms) ------------------------------------------------------------
87A2s
PGM ——Forward Peak Gate Power Dissipation (Ta=25℃) ---------------------------------------------------
5W
PG(AV) ——Forward Average Gate Power Dissipation (Ta=25℃,t=8.3ms) ---------------------------------0.5W
IFGM ——Forward Peak Gate Current -------------------------------------------------------------------------------- 2A
VRGM ——Reverse Peak Gate Voltage ------------------------------------------------------------------------------- 5V
HCP12C60
Shantou Huashan Electronic Devices Co.,Ltd.
█ Electrical Characteristics(Ta=25℃ unless otherwise specified)
Symbol
IDRM
Items
Min.
Repetitive Peak Off-State
Current
Typ.
Max.
Unit
Conditions
uA
V
VAK=VDRM
Tc=25℃
Tc=125℃
ITM=24A,tp=380µs
VTM
Peak On-State Voltage (1)
10
200
1.6
IGT
Gate Trigger Current(2)
15
mA
VAK =6V(DC), RL=10 ohm
VGT
Gate Trigger Voltage (2)
1.5
V
VAK =6V(DC), RL=10 ohm
Tc=25℃
VGD
Non-Trigger Gate Voltage
V
VAK =12V, RL=100 ohm
Tc=125℃
IH
0.2
Holding Current
20
mA
IT=100mA,Gate open,
Tc=25℃
Rth(j-c)
Thermal Resistance
1.3
℃/W
Junction to Case
Rth(j-a)
Thermal Resistance
60
℃/W
Junction to Ambient
V/µs
Linear slope up to VD=VDRM67%
Gate open
Tj=125℃
dv/dt
Critical Rate of Rise Off-state
Voltage
200
1. Forward current applied for 1 ms maximum duration,duty cycle ≤1%.
2. RGK current is not included in measurement
█ Performance Curves
FIGURE 2 – Maximum CaseTemperture
Gate Voltage (v)
Max. Allowable Case Temperture (°c)
FIGURE 1 – Gate Characteristics
Gate
Current
(mA)
Average On-State Current (mA)
Shantou Huashan Electronic Devices Co.,Ltd.
FIGURE 4-Thermal Response
On-State Current(A)
Transient Thermal Imperdance (°c)
FIGURE 3-Typical Forward Voltage(V)
HCP12C60
On-State Voltage (V)
Time (sec)
FIGURE 5-Typical Gate Trigger Voltage VS
FIGURE 6-Typical Gate Trigger Current VS
Junction Temperature
Junction Temperature
Junction Temperature (°C)
Junction Temperature (°C)
Junction Temperature (°C)
Dissipation (W)
FIGURE 8-Power Dissipation
Max. Average Power
FIGURE 7-Typical Holding Current
Average On-State Current (A)