FMV-574 Simplex V/Duplex A/D (Optional) One-way Video Configurable with 1 Duplex Audio or Data The FMV-574 is a simplex Video transmission system with one duplex port, configurable to either Audio or Data. Status indicators on Video, Sync, Data, carrier detect, voltage, temperature, and optical levels are monitored via LEDs. Video either Audio System Design All units come in a small module or Insert Card version. The cards can be inserted into our 18-slot, 19” rack mountable card cage (CC-18-80W), or one of our smaller Desktop Card Racks (DTCR series). or Data The Desktop Card Racks can handle one, two, four, or seven cards, allowing for greater flexibility and future expansion. They can sit on a flat surface as a larger stand-alone unit, or can be surface mounted with the flanges provided. Each one of our card housings operates with an appropriate power supply. The regulated switching power supply has short circuit protection and an input operating voltage of 85-265 VAC. 865 1310 1550 1270-1610 Type Wavelength Mode Suffix Features • Multimode or singlemode operation over one fiber • 10 Hz to 20 KHz audio bandwidth • True DC restoration • Flat frequency response • Complies with RS-170 and RS-170A EIA video standards • Compatible with NTSC, PAL and SECAM • No EMI or RFI and no ground loops • Stand Alone or Rack Mount • Ideal for CCTV camera & PTZ, traffic surveillance control and ITS Fiber Type Output Power Receiver Sensitivity Optical Loss Budget Range* Conn Type (CWDM) • • • • • • • LED MM L0/L1 50/125µ 62.5/125µ -16 dBm -34 dBm 18 dB 3 km ST Laser SM L2/L3 09/125µ -10 dBm -34 dBm 24 dB 25 km FC Laser SM L4 09/125µ -3 dBm -36 dBm 33 dB 25-90 km FC * Chromatic dispersion and additional losses should be taken into account. 800-867-8426 • [email protected] • www.opticomm.com • Contact Opticomm for custom requirements. Opticomm reserves the right to change specifications without notice Composite Video, Audio & Data Video Video in/out impedance Video in/out level Video bandwidth Differential gain Differential phase Linearity Tilt Compatibility Signal to noise ratio FM carrier frequency Connector type Audio Audio in/out impedance Audio in/out level Frequency response Signal to noise ratio Total harmonic distortion Connector type Data Data rate Bit error rate Data formats available Connector type General Dimensions & Weight Operating temperature Storage temperature Humidity Operating voltage Vibration Shock 75 Ω 1 volt peak to peak, 1.5 volts max 5 Hz to 7 MHz @ -3dB < 1.0 % typical < 1.0° typical ± 1.1 % typical ≤ 0.5 % typical NTSC, PAL, SECAM, RS-170, RS-170A >67 dB using RS-250C standards @ 1 km 70 MHz BNC 600 Ω or 10k Ω − balanced or unbalanced -6 to +6 dBm 10 Hz to 20 KHz > 60 dB < 1.0 %, 1 KHz at maximum modulation Hi-density 15 pin DB9 (DE15) DC to 300 Kbps 10-9 Async RS-232, RS-422, RS-485/2W, Genock, Manchester, 20 mA current loop, TTL, or six Contact Closures Hi-density 15 pin DB9 (DE15) Stand Alone (SA): 7.16” L x 5.21” W x .94” H 39 oz Insert Card (IC): 6.3” L x 0.8” W x 4.0” H 16 oz -20° C to +70° C -30° C to +85° C 0 to 95% non-condensing 12 VDC (200 mA) or 9-24 VAC (6W) or 110/220 VAC Up to 5 g's Up to 12 g's Diagnostics Status monitoring Sample Configuration LED indication Optiva™™Configurable Multi-Signal Optiva Transmission Platform Platform Communication Network Management Management Network SDI HD-SDI SDIand & HD-SDI Composite Video, Video, Composite Audio & & Data Data Audio Audio/FSK/Intercom RGB/VGA/DVI RGB/VGA/DVI Audio/FSK/Intercom Data (Ethernet/Serial/USB) (Ethernet/Serial/USB) Data CATV/RF & & L-Band L-Band CATV/RF Optical Switching, Switching, Routing Routing Optical & Redundancy & Redundancy Passive Multiplexing Multiplexing Passive Solutions Solutions Enclosures, Racks Racks Enclosures, & Frames Frames & Power Supplies Supplies Power and Accessories & Accessories MADE IN THE USA