OPTICOMM FMV

FMV-586
Simplex V/Duplex A & D
One-way Video, One Duplex Audio,
and One Duplex Data for PTZ
The FMV-586 is a simplex Video
transmission system with one duplex
Audio port and and one duplex Data
port for PTZ, ideal for CCTV cameras
and traffic surveillance. Status
indicators on Video, Sync, Data, carrier
detect, voltage, temperature, and
optical levels are monitored via LEDs.
Video
Audio
System Design
All units come in a small module or
Insert Card version. The cards can be
inserted into our 18-slot, 19” rack
mountable card cage (CC-18-80W), or
one of our smaller Desktop Card Racks
(DTCR series).
Data
The Desktop Card Racks can handle
one, two, four, or seven cards, allowing
for greater flexibility and future
expansion. They can sit on a flat
surface as a larger stand-alone unit, or
can be surface mounted with the
flanges provided. Each one of our card
housings operates with an appropriate
power supply. The regulated switching
power supply has short circuit
protection and an input operating
voltage of 85-265 VAC.
865
1310
1550
1270-1610
Type
Wavelength
Mode
Suffix
Features
• Multimode or singlemode operation over one fiber
• 10 Hz to 20 KHz audio bandwidth
• True DC restoration
• Flat frequency response
• Complies with RS-170 and RS-170A EIA video standards
• Compatible with NTSC, PAL and SECAM
• No EMI or RFI and no ground loops
• Stand Alone or Rack Mount
• Ideal for CCTV cameras, surround sound, traffic
surveillance control, and ITS
Fiber
Type
Output
Power
Receiver
Sensitivity
Optical
Loss
Budget
Range*
Conn
Type
(CWDM)
•
•
•
•
•
•
•
LED
MM
L0/L1
50/125µ
62.5/125µ
-16 dBm
-34 dBm
18 dB
3 km
ST
Laser
SM
L2/L3
09/125µ
-10 dBm
-34 dBm
24 dB
25 km
FC
Laser
SM
L4
-3 dBm
-36 dBm
33 dB
25-90 km
FC
09/125µ
* Chromatic dispersion and additional losses should be taken into account.
800-867-8426 • [email protected] • www.opticomm.com • Contact Opticomm for custom requirements.
Opticomm reserves the right to change specifications without notice
Composite Video,
Audio & Data
Video
Video in/out impedance
Video in/out level
Video bandwidth
Differential gain
Differential phase
Linearity
Tilt
Compatibility
Signal to noise ratio
FM carrier frequency
Connector type
Audio
Audio in/out impedance
Audio in/out level
Frequency response
Signal to noise ratio
Total harmonic distortion
Connector type
Data
Data rate
Bit error rate
Data formats available
Connector type
General
Dimensions & Weight
Operating temperature
Storage temperature
Humidity
Operating voltage
Vibration
Shock
75 Ω
1 volt peak to peak, 1.5 volts max
5 Hz to 7 MHz @ -3dB
< 1.0 % typical
< 1.0° typical
± 1.1 % typical
≤ 0.5 % typical
NTSC, PAL, SECAM, RS-170, RS-170A
>67 dB using RS-250C standards @ 1 km
70 MHz
BNC
600 Ω or 10k Ω − balanced or unbalanced
-6 to +6 dBm
10 Hz to 20 KHz
> 60 dB
< 1.0 %, 1 KHz at maximum modulation
Hi-density 15 pin DB9 (DE15)
DC to 300 Kbps
10-9
Async RS-232, RS-422, RS-485/2W, Genlock, Manchester,
20 mA current loop, TTL, or six Contact Closures
Hi-density 15 pin DB9 (DE15)
Stand Alone (SA): 7.16” L x 5.21” W x .94” H
39 oz
Insert Card (IC): 6.3” L x 0.8” W x 4.0” H
16 oz
-20° C to +70° C
-30° C to +85° C
0 to 95% non-condensing
12 VDC (200 mA) or 9-24 VAC (6W) or 110/220 VAC
Up to 5 g's
Up to 12 g's
Diagnostics
Status monitoring
Sample Configuration
LED indication
Optiva™™Configurable
Multi-Signal
Optiva
Transmission Platform
Platform
Communication
Network Management
Management
Network
SDI
HD-SDI
SDIand
& HD-SDI
Composite Video,
Video,
Composite
Audio &
& Data
Data
Audio
Audio/FSK/Intercom
RGB/VGA/DVI
RGB/VGA/DVI
Audio/FSK/Intercom
Data (Ethernet/Serial/USB)
(Ethernet/Serial/USB)
Data
CATV/RF &
& L-Band
L-Band
CATV/RF
Optical Switching,
Switching, Routing
Routing
Optical
&
Redundancy
& Redundancy
Passive Multiplexing
Multiplexing
Passive
Solutions
Solutions
Enclosures, Racks
Racks
Enclosures,
& Frames
Frames
&
Power Supplies
Supplies
Power
and
Accessories
& Accessories
MADE IN THE USA