RF SAW Filter Part Number Package Application Last Modified 802-RF810.0M-A 3.0 x 3.0 SMD Wireless Mar.10, 2007 . TYPE : Wireless, RF SAW Filter PART NUMBER : 802-RF810.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 810.0 - MHz 805.0~ 815.0 MHz - 2.9 3.5 dB Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm Operating Temperature Range - -40 - +85 ºC 805.0~ 815.0 MHz - 0.6 1.5 dBp-p 10 dB Bandwidth - - 24.5 30.0 MHz 20 dB Bandwidth - - 30.0 40.0 MHz 40 dB Bandwidth - - 49.0 60.0 MHz 805.0~ 815.0 MHz - 20.0 40.0 nsec Maxium DC Voltage - - - 5 V Maxium Input Power - - - 10 dBm Center Frequency (Fo) Maximum Insertion Loss Amplitude Ripple Group Delay Variation * No Matching Network(Ref. Testing Environment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE Source/ Load Impedance = 50 ohms A Ground B Out C Ground D Ground E In F Ground FREQUENCY RESPONSE GROUP DELAY SMITH CHART Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF810.0M-A