RF SAW Filter Part Number Package Application Last Modified 802-RF813.5M-A 3.0 x 3.0 SMD Wireless Mar. 2, 2007 . TYPE : Low-Loss RF SAW Filter For Wireless Communication PART NUMBER : 802-RF813.5M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 813.5 - MHz Maximum Insertion Loss 806.0~ 821.0 MHz - 2.2 3.0 dB Attenuation: 851.0~ 866.0 MHz 40 50 - 935.0~940.0 MHz 35 40 - 960.65~ 979.65MHz 35 41 - 1115.30~ 1134.30 MHz 37 42 - 1269.95~ 1288.95 MHz 40 51 - 1612.0~ 1650.0 MHz 35 43 - 1650.0~ 2600.0 MHz 25 30 - - - 50 - Center Frequency (Fo) Source Impedence (single ended)* dB ohm - - 50 - ohm VSWR 806.0~ 821.0 MHz - 1.7 2.0 dBp-p Group Delay Ripple Load Impendance (single ended)* 806.0~ 821.0 MHz - 15 30 nsp-p Maximum DC Voltage - - - 5 V Maximum Input Power - - - 20 dBm Operating Temperature - -30 - +70 ºC * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: 802-RF813.5M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map