RF SAW Filter Part Number Package Application Last Modified 802-RF770.0M-A 3.0 x 3.0 SMD Wireless Communication Mar. 2, 2007 . TYPE : RF SAW Filter for Wireless Communication PART NUMBER : 802-RF770.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 770.0 - MHz Maximum Insertion Loss 760.0~ 780.0 MHz - 2.2 3.0 dB Attenuation: 560.0~ 730.0 MHz 50 58 - 824.0~ 849.0 MHz 38 45 - 849.0~ 970.0MHz 50 58 - - - 50 - Center Frequency (Fo) Source Impedence (single ended)* Load Impendance (single ended)* Amplitude Ripple Maxium DC Voltage VSWR dB ohm - - 50 - ohm 760.0~ 780.0 MHz - 0.7 1.5 dB p-p - - - 5 V 760.0~ 780.0 MHz - 1.45 2.0 - Maximum Input Power - - - 15 dBm Operating Temperature - -30 - +65 ºC * No Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE Source/ Load Impedance = 50 ohms A Ground B Out C Ground D Ground E In F Ground FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF770.0M-A