Oscilent Corporation RF SAW Filter | 805-RF434.46M-A Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 805-RF434.46M-A 5.0 x 5.0 SMD Remote Control Jan. 01, 2007 . TYPE : Remote Control, RF SAW Filter PART NUMBER : 805-RF434.46M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss Relative Attenuation: Terminating Impedance Relative Passband Relative Passband Condition Minimum Typical Maximum Units - - 434.46 - MHz 434.30 ~ 434.62 MHz - 2.5 4.0 dB 10.0 ~ 414.5 MHz 45 50 - 414.50 ~ 428.50 MHz 30 36 - 428.50~433.42 MHz 15 23 - 435.42 ~ 442.50 MHz 10 15 - 442.50 ~ 550.0 MHz 30 38 - 550.0 ~ 1000.0 MHz 45 55 - - - 50 - ohm 434.24 ~ 434.68 MHz - 1.0 3.0 dB dB dB 434.18 ~ 434.74 MHz - 1.5 6.0 Maximum DC Voltage - - - 0 V Maximum Input Power - - - 10 dBm Storage Temperature - -40 - +85 ºC FTC - - 0.032 - ppm/ºC Operating Temperature - -40 - +85 ºC * Maximum Rating (Ta=25 ºC) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A In B Ground C Ground D Ground E Out F Ground G Ground H Ground Oscilent Corporation RF SAW Filter | 805-RF434.46M-A Page 2 of 2 FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 805-RF434.46M-A