Oscilent Corporation IF SAW Filter | 807-IF456.0M-A Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 807-IF456.0M-A 7.0 x 5.0 SMD Mobile Communication Jan. 01, 2007 . TYPE : 456.0 MHz IF SAW Filter 7.60 MHz Bandwidth PART NUMBER : 807-IF456.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 455.7 456.0 456.3 MHz Insertion Loss at Fo - 14.5 16.5 dB Bandwidth at -3.0 dB 7.0 7.6 - MHz Bandwidth at -40.0 dB - 12.6 14.0 MHz 45 - dB Center Frequency - Relative Attenuation Lower Sidelobe 40 Upper Sidelobe 40 43 - dB Temperature Coefficient - 0.03 - ppm/°C Source Impedance (Balanced)* - 200 - ohm Load Impedance (Balanced)* - 200 - ohm Amplitude Ripple - 1.0 1.5 dBp-p Group Delay Variation - 120 200 ns Operating Temperature -40 - +85 °C - 0.520 1.0 µsec Absolute Delay at Fo * With Matching Network (Ref. Testing Environment Circuit as shown) Modification to Impedance Values are possible if needed. . PACKAGE OUTLINE (mm) Oscilent Corporation IF SAW Filter | 807-IF456.0M-A Page 2 of 2 TEST CIRCUIT TEST FIXTURE AND VALUES/SOURCE AND LOAD IMPEDANCE 50 ohm INPUT: L1: 30 nH; C1: 7pF OUTPUT: L2: 24 nH; C2: 9pF FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 807-IF456.0M-A