Oscilent Corporation IF SAW Filter | 820-IF160.0M-F Page 1 of 3 IF SAW Filter Part Number Package Application Last Modified 820-IF160.0M-F 20.2 x 12.6 Thru Hole Base Station & Repeater Jan. 01, 2007 . TYPE : 160.0 MHz Bandpass Filter 1.5 MHz Bandwidth PART NUMBER : 820-IF160.0M-F .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 159.95 160.00 160.05 MHz Insertion Loss at Fo - 19.0 22.0 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm 1.5dB Bandwidth 1.26 1.35 - MHz 3.0dB Bandwidth 1.40 1.50 - MHz 35.0dB Bandwidth - 2.25 2.40 MHz 50.0dB Bandwidth - 2.38 2.50 MHz Passband Ripple Fo +/- 0.5 MHz - 0.6 1.0 dBp-p Group Delay Variation Fo +/- 0.63 MHz - 180 300 nsec Center Frequency (Fo) - 2.5 - µsec Rejection 162 ~167 MHz 50 55 - dB Ultimate Rejection Fo-9.0~Fo-2.0MHz 50 55 - dB Ultimate Rejection Fo+2.0~Fo+9.0MHz 50 55 - dB - - 10 V Absolute Delay Maximum DC Voltage - - 10 dBm Operating Temperature Range -40 - +85 °C Storage Temperature Range -60 - +85 °C Maximum Input Power *With Matching Network (Ref. Testing Environment Circuit as shown below) . PACKAGE OUTLINE (mm) Oscilent Corporation IF SAW Filter | 820-IF160.0M-F PIN DESCRIPTIONS: IN - 2, OUT - 4, GROUND -1,3,5,6 TEST CIRCUIT TEST FIXTURE AND VALUES/SOURCE AND LOAD IMPEDANCE 50 ohm INPUT: OUTPUT: L1: 56 nH; C1: 30 pF L2: 56 nH; C2: 15 pF COMPONENT VALUES MAY VARY DUE TO PCB PARASITICS FREQUENCY RESPONSE Page 2 of 3 Oscilent Corporation IF SAW Filter | 820-IF160.0M-F Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 820-IF160.0M-F