Oscilent Corporation IF SAW Filter | 809-IF85.38M-G Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 809-IF85.38M-G 9.1 x 4.8 SMD Mobile Communication Jan. 01, 2007 TYPE : 85.38 MHz IF SAW Filter PART NUMBER : 809-IF85.38M-G OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency - 85.38 - MHz Insertion Loss at Fo - 9.6 12.5 dB Attenuation Fo +630 kHz - 3.8 5.0 dB Attenuation Fo -630 kHz - 3.8 5.0 dB Attenuation Fo +900 kHz 33 41 - dB Attenuation Fo -900 kHz 33 44 - dB Attenuation Fo +1.7 MHz 35 43 - dB Attenuation Fo -1.7 Mhz 35 42 - dB Source Impedance (Single Ended)* - 50 - ohm Load Impedance (Single Ended)* - 50 - ohm Substrate Material - Quartz - - Passband Ripple at Fo + 300 kHz - 0.7 1.2 dB * With Matching Network (Ref. Testing Environment Circuit as shown below) Those impedances could be modified with different impedance values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. PACKAGE OUTLINE (mm) TEST CIRCUIT Oscilent Corporation IF SAW Filter | 809-IF85.38M-G Page 2 of 2 SOURCE AND LOAD IMPEDANCE: 50 ohm INPUT: L1: TBD nH, C1: TBD pF L3: TBD nH OUTPUT: L2: TBD nH, C2:TBD pF L4: TBD nH FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 809-IF85.38M-G