657 Watts Total Power: 657 Watts Input Voltage: 85-264 VAC # of Outputs: Two & Standby DS657-9-3 Electrical Specs Input Input Range Frequency Inrush Current Efficiency EMI Filter Power Factor Leakage Current Special Features • • • • • • • • • • • • • • • • • • • • 85-264VAC 47 - 63 Hz 17A max, 115VAC, 25°C 80% typical at full load, 115VAC Class A 0.99 typical 2mAmaximum @ 240 VAC Output EN61000-3-2 Harmonic Compliance Active Power Factor Correction Active Current Share 1U high FCC 47 CFR Part 15 Class A (US) CISPR22 Class A EN55022:1998 (Europe) EN61000 Immunity Standards 12V standby Fan Speed Control Over Current Protection (OCP) Over Voltage Protection (OVP) Over Temperature Protection (OTP) IEC320 AC Inlet On/off switch I2C Communications No minimum load required 2250VDC Isolation IEEE 802.3af Compliant Power Source 1 year warranty Maximum Power 657W Hold Up Time 20ms (minimum) Over Current 110% - 130% of nominal Autorecovery Protection (OCP) Short Circuit Latch off main outputs if one Protection of the main output short circuits to common Over Voltage Protection (OVP) 107% - 117% of nominal Latch, AC recycle to reset Logic Control AC OK DC OK ENABLE TTL signal HIGH TTL signal LOW Logic LOW (<1V) capable of 2mA sink current Environmental Operating Temperature: 0°C to 50°C (50% power derating at 70°C) Safety MTBF (MIL HDBK 217F):>100KHrs at full load, 40°C Humidity: Operating: 85% RH, non-condensing Non-operating: 95% RH, non-condensing UL/cUL 60950 3rd Edition TUV EN60950 3rd Edition IEC60950 3nd Edition CE Mark EN60950 3rd Edition Electromagnetic Susceptibility: Designed to meet EN61000-4-2, 4-3, 4-4, 4-5, 4-6, 4-11 Level 3 152 Americas: 1-888-41-ASTEC Europe (UK): 44 (1384) 842-211 Asia (HK): 852-2437-9662 rev 04.27.05 DS657-9 9-3 3 AMERICAS EUROPE ASIA 5810 Van Allen Way Carlsbad, CA 92008 Telephone: 760-930-4600 Facsimile: 760-930-0698 Astec House, Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX, UK Telephone: 44 (1384) 842-211 Facsimile: 44 (1384) 843-355 Units 2111-2116, Level 21 Tower1, Metroplaza 223, Hing Fong Road Kwai Fong, New Territories Hong Kong Telephone: 852-2437-9662 Facsimile: 852-2402-4426 DC Output Voltages Output Voltage(V) Regulation V1 V2 V3 +48V/+51V 12V 12V ±5% ±5% ±5% Minimum Load (A) 0.0 0.0 0.0 Maximum Load (A) 10.0 12.0 0.5 Ripple(peak-p peak) 500mV 120mV 120mV Notes: 1.Ripple and noise tested with 10µF capacitor in parallel with a 0.1µF capacitor, 20MHz bandwidth. DS657-9 9-3 3 Mechanical Drawings: PSU Connector: FCI 51720-1 10202402AA 1 2 3 4 5 6 J K N S P1 P2 P3 Mating Connector FCI 51740-1 10202402AA www.astecpower.com P4 Pin Signal Reference Location P1 12V Output P2 12V Output RTN 1J 12V + Sense 1K 12V - Sense 1N 12V Current-Share 1S Power Supply Present 2J Serial Data Line 2K Serial Clock Line 2N Address Input 0 2S Address Input 1 3J 12V Aux Output RTN 3K 12V INHIBIT 3N 51V INHIBIT 3S Address Input 2 4J 12V Aux Output 4K DC OK 4N AC OK 4S FANFAIL / OTP 5J NOT CONNECTED 5K NOT CONNECTED 5N NOT CONNECTED 5S NOT CONNECTED 6J 51V + Sense 6K 51V - Sense 6N 51V Current-Share 6S NOT CONNECTED P3 51V Output RTN P4 51V Output 153 DS657-9-3 Logic Signal 1. 12V Remote Sense 6. AC OK (Out Signal) Pin 1J - 12V +Sense Pin 4N AC NOT OK Pin 1K Compensates for up to 0.5V drop. Recommended shielded twisted wire pair. Pin 3J 2. 12V Current-Share (In/Out Signal) Pin 1 J Pin P2 C-Share Pin is used when connecting units in parallel to achieve current sharing. Current share accuracy is typically 10% of full load. AC OK 0V IN LED: ON OFF OUT LED: ON OFF 7. FANFAIL/OTP (OUT Signal) Pin 4S FAN NOT OK Note: Current-Share voltage is 1.5V at 100% load current (12A) 3. 12V Inhibit (In Signal) Pin 3J Pin 3K 12V O/P Disabled Pin 3J 8. 51V Remote Sense 12V O/P Enabled 0V OUT LED: ON OFF Pin 6J 51V +Sense Pin 6K 51V -Sense Compensates for up to 0.5V drop. Recommended shielded twisted wire pair. 4. 51V Inhibit (In Signal) 51V O/P Disabled Pin 3N Pin 3J FAN OK 0V TEMP LED OFF ON AC OK LED: ON OFF DC OK LED: ON OFF 9. 51V Current-Share (In/Out Signal) Pin 6N C-Share Pin is used when connecting units in parallel to achieve current sharing. Current share accuracy is typically 10% of full load. 51 O/P Enabled 0V OUT LED: ON OFF Pin P3 Note: Current-Share voltage is 2.5V at 100% load current (10A) 5. DC OK (Out Signal) Pin 4K Pin 3J 154 DC NOT OK DC OK 0V IN LED: ON OFF OUT LED: ON OFF North America (USA): 1-888-41-ASTEC Europe (UK): 44 (1384) 842-211 Asia (HK): 852-2437-9662 rev 04.27.05 119.5 2K : SCL 3K : Vo2 ENA 4K : OGOOD 5K : NC 6K : Vo1 - S 3J : Vaux RTN 4J : Vaux 5J : NC 6J : Vo1 + S 1J : Vo2 + S 2J : SDA OUTPUT PIN DESIGNATION 1K : Vo2 - S ASTEC ID: MADE IN SERIAL NO: CIEI# @10A 5N : NC 6N : Vo1 - CS 3N : Vo1 ENA 4N : PF 1N : Vo2 - CS 2N : A0 PHILIPPINES @0.25A @12A 5S : NC 6S : NC 4S : OTF 1S : PS - UP 2S : A1 3S : A2 Units 2111-2116, Level 21 Tower1, Metroplaza 223, Hing Fong Road Kwai Fong, New Territories Hong Kong Telephone: 852-2437-9662 Facsimile: 852-2402-4426 DATE: 0402 REV: 0A Astec House, Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX, UK Telephone: 44 (1384) 842-211 Facsimile: 44 (1384) 843-355 OUTPUTS: Vo1 : 51V Vo2 : 12V Vaux : 12V 5810 Van Allen Way Carlsbad, CA 92008 Telephone: 760-930-4600 Facsimile: 760-930-0698 ENG# ASIA INPUT: 100-240VAC 50/60HZ 11.5A max 260.4 EUROPE MAXIMUM OUTPUT POWER IS 650W MODEL DS657-9-3 365.0 381.0 342.9 127.1 15.5 40.4 www.astec.com AMERICAS DS657-9-3 PSU Outline 155 4.6 135.2 20.2 29.4