YP-350J-AA 350W ATX with 24V industrial PC Power Supply Features : Universal AC input / Full range Built-in active PFC function, PF>0.95 Protections: Short circuit / Overload / Over voltage Power good and fail signal FAN speed control function Power ON-OFF switch with indicator Forced air cooling by built-in DC fan 100% full load burn-in test Approvals: UL / CUL / TUV / CB / FCC / CE 2 years warranty SPECIFICATION ORDER NO. OUTPUT YP-350J-AA SAFETY MODEL NO. YP-350J CHANNEL DC VOLTAGE CH1 3.3V CH2 5V CH3 12V CH4 24V CH5 -5V CH6 -12V STANDBY 5VSB MINIMUM CURRENT 0.3A 0.1A 0A 0A 0A 0A 0A RATED CURRENT 9A 15A 9A 5A 0.3A 0.8A 2.0A MAXIMUM CURRENT 14A 21A 15A 5A 0.3A 0.8A 2.0A 150mVp-p 100mVp-p 120mVp-p 50mVp-p 135W max. For +5V and +3.3V output COMBINE LOAD 210W max. For +5V, +3.3V and +12V output 350W continue load RATED POWER (max.) RIPPLE & NOISE (max.) Note.2 50mVp-p LINE REGULATION LOAD REGULATION INPUT Note.3 5.0% -2.0 ~ +8.0% VOLTAGE RANGE 100 ~ 264VAC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR PF>0.95@230VAC EFFICIENCY (Typ.) 70% AC CURRENT INRUSH CURRENT (max.) 8.0A / 115VAC PROTECTION OVER VOLTAGE SHORT CIRCUIT POWER GOOD SIGNAL POWER FAIL SIGNAL PS-ON INPUT SIGNAL WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SAFETY & ISOLATION RESISTANCE EMC EMI CONDUCTION & RADIATION (Note 4) HARMONIC CURRENT EMS IMMUNITY MTBF CONNECTOR COOLING DIMENSION PACKING NOTE 5.0% 40A / 115VAC 3.5mA / 240VAC 120mVp-p 1.0% 10ms min. at full load (Rated current) OVERLOAD OTHERS 1.0% HOLD UP TIME LEAKAGE CURRENT FUNCTION 50mVp-p 1.0% 1.0% -2.0 ~ +8.0% 2.0% 2.0% 1.0% 5.0% 10% 5.0% PF>0.98@115VAC 4.5A / 230VAC 80A / 230VAC 105 ~ 180% rated output power Protection type : Shut down o/p voltage, re-power on to recover 110% ~ 130% of rated voltage for +3.3V, +5V and +12V Protection type : Shut down o/p voltage, re-power on to recover All output equipped with short circuit Protection type : Shut down o/p voltage, re-power on to recover The TTL compatible signal out with 100ms to 500ms delay after power set up The TTL compatible signal will go down at least 1ms before +5V below 4.75V Power on: PS-ON = "Low" or "<0.8V" ; Power off: PS-ON = "Hi" or ">2V" -10 ~ +40 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.05% / (0 ~ 50 ) 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes UL60950-1, TUV EN60950-1 approved I/P-O/P:1.5KVAC I/P-O/P: 50M Ohms / 500VDC / 25 / 70% RH Compliance to EN55022 (CISPR22) class B, FCC part 15 Class B Compliance to EN61000-3-2,-3 Compliance to EN61000-4-2,3,4, 5,6,8,11, light industry level, criteria A 100K hrs min. ATX main power connector * 1ea; +12V power connector * 1ea; Auxiliary power connector * 1ea Peripheral power connector * 5 ea; Floppy drive power connector * 2 ea Forced air ventilation by 8cmx8 ball bearing DC fan 171*150*86mm (L*W*H) 1.6Kg ; 12pcs / 20Kg / CARTON 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Line regulation is measured from low line to high line at rated load. 4. Load regulation is measured from 20% to 100% max. Load. 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name: YP-350J-AA-SPEC 2010-02-25 YP-350J-AA 350W ATX with 24V industrial PC Power Supply Mechanical Specification Unit: mm 150 114 150 AC INPUT CONNECTOR POWER SWICH 64 74 86 OP WIRE HARNESS AC OUTPUT CONNECTOR +12V +12V +5VSB PIN7 PIN1 GND GND GND GND 24V (C) PIN11 PIN1 +12VDC +5V SB PWR-OK GND +5VDC GND +5VDC GND +3.3VDC +3.3VDC +5VDC +5VDC -5VDC GND GND GND PS-ON GND -12VDC +3.3VDC (A) 24V +5V PIN12 PIN6 (B) GND (E) +5V (D) +12VDC COM 2 4 1 3 +12VDC COM 1 2 3 4 (D) +5VDC COM COM +12VDC 4 3 2 1 +5VDC COM COM +12VDC (E) 4 3 2 1 4 3 2 1 +5VDC COM COM +12VDC (D) +5VDC COM COM +12VDC 4 3 2 1 +5VDC COM COM +12VDC (D) +5VDC COM COM +12VDC 4 3 2 1 +5VDC COM COM +12VDC (D) L=400mm 50mm L=150mm L=150mm L=400mm 50mm L=300mm 20mm 138 1 2 3 4 L=150mm L=150mm L=150mm L=500mm 50mm L=400mm 50mm WIRE OUTPUT OF CASE NO.6-32UNC-2B THREADED HOLE(4X) (A)ATX main power connector Type: MOLEX 39-01-2200 or equivalent (B)+12V power connector Type: MOLEX 39-01-2040 or equivalent (C)Auxiliary power connector Type: MOLEX 39-01-2120 or equivalent (D)Peripheral connector Type: MOLEX 8981-04P or equivalent (E)Floppy drive connector Type: AMP 171822-4 or equivalent File Name:YP-350J-AA-SPEC 2010-02-25