YP-450A-AA 350W ATX PC Power Supply Features : AC input range selected by switch With +5VSB:0 ~ 2.0A max. Power good signal output Power fail signal output Power ON-OFF switch High efficiency / Low cost Forced air cooling by built-in DC fan 100% full load burn-in test Approvals: CSA / FCC 1 year warranty R SPECIFICATION ORDER NO. YP-450A-AA YP-450-A SAFETY MODEL NO. OUTPUT CHANNEL CH1 CH2 CH3 CH4 CH5 CH6 STANDBY DC VOLTAGE 3.3V 5V 12V1 12V2 -5V -12V 5VSB MINIMUM CURRENT 2A 2A 1A 1A 0.1A 0.1A 0A RATED CURRENT 15A 14A 7A 10A 0.3A 0.8A 2.0A MAXIMUM CURRENT 22A 21A 10A 15A 0.3A 0.8A 2.0A 120mVp-p 120mVp-p 50mVp-p 120mVp-p 50mVp-p +3.3V, +5V 130W max. COMBINE LOAD +3.3V, +5V, +12V 330W max. 350W RATED POWER (max.) RIPPLE & NOISE (max.) Note.2 50mVp-p LINE REGULATION LOAD REGULATION INPUT Note.3 1.0% 2.0% 2.0% 1.0% 5.0% 5.0% 5.0% 5.0% 10% 10% 5.0% VOLTAGE RANGE 103 ~ 132VAC / 206 ~ 264VAC selected by switch FREQUENCY RANGE 47 ~ 63Hz EFFICIENCY (Typ.) 70% 8.0A / 115VAC 40A / 115VAC AC CURRENT INRUSH CURRENT (max.) 4.5A / 230VAC 80A / 230VAC LEAKAGE CURRENT (max.) 3.5mA / 240VAC OVERLOAD 105 ~ 180% rated output power Protection type : Shut down o/p voltage, re-power on to recover POWER GOOD SIGNAL POWER FAIL SIGNAL PS-ON INPUT SIGNAL WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS SAFETY & WITHSTAND VOLTAGE EMC ISOLATION RESISTANCE (Note 4) NOTE 1.0% 8ms min. at full load SHORT CIRCUIT OTHERS 1.0% HOLD UP TIME PROTECTION OVER VOLTAGE FUNCTION 50mVp-p 1.0% +3.3V, +5V, +12V 1, +12V 2 : 110%~130% of rated voltage Protection type : Shut down o/p voltage, re-power on to recover All output equipped with short circuit Protection type : Shut down o/p voltage, re-power on to recover The TTL compatible signal out with 100ms to 500ms delay after power set up The TTL compatible signal will go down at least 1ms before +5V below 4.75V Power on: PS-ON = "Low" or "<0.8V" ; Power off: PS-ON = "Hi" or ">2V" -10 ~ +35 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.05% / ( 0 ~ 50 ) 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes CSA(C22.2 60950, UL60950) approved I/P-O/P, I/P-FG:1.5KVAC I/P-O/P, I/P-FG:50M Ohms / 500VDC / 25 / 70% RH EMI CONDUCTION & RADIATION Compliance to FCC part 15 class B 100K hrs min. MIL-HDBK-217F (25 ) MTBF ATX main power connector * 1ea; +12V power connector * 1ea; Serial ATA connector * 1ea CONNECTOR Peripheral power connector * 5 ea; Floppy drive power connector * 2 ea COOLING Forced air ventilation by 8cm DC fan DIMENSION 150*140*86mm (L*W*H) PACKING 1.1kg ; 12pcs / 16kg / CARTON 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Load regulation is measured from 20% to 100% max. Load. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name: YP-450A-AA-SPEC 2009-03-30 YP-450A-AA 350W ATX PC Power Supply Mechanical Specification Unit: mm 52.4 6#-32UND(4X) 6.0MM MAX DEEP 16 230 114 118.5 PIN13 PIN1 +12V 1 +5V SB PWR-OK GND +5VDC GND +5VDC GND +3.3VDC +3.3VDC +12V 1 +3.3VDC COM +5VDC +5VDC +5VDC -5VDC GND GND GND PS-ON GND -12VDC +3.3VDC (A) +12V 1 COM +5VDC COM +3.3VDC COM 2 1 COM 5 4 3 2 1 1 2 3 4 (D) +5VDC COM COM +12V 1 (D) +12V 2 4 3 +12V 2 (E) L=300mm 20mm L=300mm 20mm L=150mm L=150mm 4 3 2 1 +5VDC COM COM +12V1 (D) 4 3 2 1 4 3 2 1 +5VDC COM COM +12V1 (D) +5VDC COM COM +12V1 4 3 2 1 +5VDC COM COM +12V1 (D) +5VDC COM COM +12V 1 4 3 2 1 +5VDC COM COM +12V1 1 2 3 4 L=150mm L=150mm L=300mm 20mm AC INPUT CONNECTOR L=300mm 20mm L=150mm L=300mm 20mm WIRE OUTPUT OF CASE WIRE OUTPUT HOLE 25.9 43.55 62.05 74 64 43.45 138 (B) (C) (E) (A)24 Pin ATX main power connector(or 20+4pin) (B)+12V power connector Type: MOLEX 39-01-2240 or equivalent Type: MOLEX 39-01-2040 or equivalent (C)Serial ATA connector Type: MOLEX 88751 or equivalent (D)Peripheral connector Type: MOLEX 8981-04P or equivalent (E)Floppy drive connector Type: AMP 171822-4 or equivalent File Name: YP-450A-AA-SPEC 2009-03-30 YP-450A-EU 350W ATX PC Power Supply Features : 230VAC input only Built-in passive PFC, PF>0.65 With +5VSB:0 ~ 2.0A max. Power good signal output Power fail signal output Power ON-OFF switch High efficiency / Low cost Forced air cooling by built-in DC fan 100% full load burn-in test Approvals: TUV / CE 1 year warranty SPECIFICATION ORDER NO. YP-450A-EU YP-450-A SAFETY MODEL NO. OUTPUT CHANNEL CH1 CH2 CH3 CH4 CH5 CH6 STANDBY DC VOLTAGE 3.3V 5V 12V1 12V2 -5V -12V 5VSB MINIMUM CURRENT 2A 2A 1A 1A 0.1A 0.1A 0A RATED CURRENT 15A 14A 7A 10A 0.3A 0.8A 2.0A MAXIMUM CURRENT 22A 21A 10A 15A 0.3A 0.8A 2.0A 120mVp-p 120mVp-p 50mVp-p 120mVp-p 50mVp-p +3.3V, +5V 130W max. COMBINE LOAD +3.3V, +5V, +12V 330W max. 350W RATED POWER (max.) RIPPLE & NOISE (max.) Note.2 50mVp-p LINE REGULATION LOAD REGULATION INPUT Note.3 1.0% 2.0% 2.0% 1.0% 5.0% 5.0% 5.0% 5.0% 10% 10% 5.0% VOLTAGE RANGE 206 ~ 264VAC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR (Typ.) EFFICIENCY (Typ.) PF>0.65 / 230VAC 70% 5A / 230VAC 80A / 230VAC LEAKAGE CURRENT (max.) 3.5mA / 240VAC OVERLOAD 105 ~ 180% rated output power Protection type : Shut down o/p voltage, re-power on to recover SHORT CIRCUIT POWER GOOD SIGNAL POWER FAIL SIGNAL PS-ON INPUT SIGNAL WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SAFETY & ISOLATION RESISTANCE EMC EMI CONDUCTION & RADIATION (Note 4) HARMONIC CURRENT EMS IMMUNITY MTBF CONNECTOR NOTE 1.0% 8ms min. at full load PROTECTION OVER VOLTAGE OTHERS 1.0% HOLD UP TIME AC CURRENT INRUSH CURRENT (max.) FUNCTION 50mVp-p 1.0% +3.3V, +5V, +12V 1, +12V 2 : 110%~130% of rated voltage Protection type : Shut down o/p voltage, re-power on to recover All output equipped with short circuit Protection type : Shut down o/p voltage, re-power on to recover The TTL compatible signal out with 100ms to 500ms delay after power set up The TTL compatible signal will go down at least 1ms before +5V below 4.75V Power on: PS-ON = "Low" or "<0.8V" ; Power off: PS-ON = "Hi" or ">2V" -10 ~ +35 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.05% / ( 0 ~ 50 ) 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes TUV EN60950-1 approved I/P-O/P, I/P-FG:1.5KVAC I/P-O/P, I/P-FG:50M Ohms / 500VDC / 25 / 70% RH Compliance to EN55022 (CISPR22) class B Compliance to EN61000-3-2,-3 Compliance to EN61000-4-2,3,4,5,6,8,11, light industry level, criteria A 100K hrs min. MIL-HDBK-217F (25 ) ATX main power connector * 1ea; +12V power connector * 1ea; Serial ATA connector * 1ea Peripheral power connector * 5 ea; Floppy drive power connector * 2 ea COOLING Forced air ventilation by 8cm DC fan DIMENSION 150*140*86mm (L*W*H) PACKING 1.1kg ; 12pcs / 16kg / CARTON 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Load regulation is measured from 20% to 100% max. Load. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name: YP-450A-EU-SPEC 2009-04-06 YP-450A-EU 350W ATX PC Power Supply Mechanical Specification Unit: mm 52.4 6#-32UND(4X) 6.0MM MAX DEEP WIRE OUTPUT HOLE 16 25.9 62.05 74 64 43.45 138 L=150mm L=150mm PIN13 PIN1 +12V 1 +5V SB PWR-OK GND +5VDC GND +5VDC GND +3.3VDC +3.3VDC +12V 1 +3.3VDC COM +5VDC +5VDC +5VDC -5VDC GND GND GND PS-ON GND -12VDC +3.3VDC (A) +12V 1 COM +5VDC COM +3.3VDC COM 2 1 COM (D) +12V 2 4 3 +12V 2 (D) 5 4 3 2 1 1 2 3 4 4 3 2 1 +5VDC COM COM +12V1 (E) +5VDC COM COM +12V 1 4 3 2 1 (D) +5VDC COM COM +12V1 4 3 2 1 +5VDC COM COM +12V1 (D) +5VDC COM COM +12V 1 4 3 2 1 +5VDC COM COM +12V1 1 2 3 4 L=150mm L=150mm L=150mm 4 3 2 1 +5VDC COM COM +12V1 (D) L=300mm 20mm L=300mm 20mm L=300mm 20mm AC INPUT CONNECTOR L=300mm 20mm L=300mm 20mm WIRE OUTPUT OF CASE 114 118.5 (B) (C) (E) (A)24 Pin ATX main power connector(or 20+4pin) (B)+12V power connector Type: MOLEX 39-01-2040 or equivalent Type: MOLEX 39-01-2240 or equivalent (C)Serial ATA connector Type: MOLEX 88751 or equivalent (D)Peripheral connector Type: MOLEX 8981-04P or equivalent (E)Floppy drive connector Type: AMP 171822-4 or equivalent File Name: YP-450A-EU-SPEC 2009-04-06