75 Ohm N Female Connector Clamp/Solder Attachment For RG59, RG62, .480 inch D Hole TECHNICAL DATA SHEET PE4516 75 Ohm N Female Connector Clamp/Solder Attachment For RG59, RG62, .480 inch D Hole Configuration Connector Connector Interface Type Cable Attachment Method (Shield/Contact) Body Style N Female RG59,RG62 Clamp/Solder Straight Electrical Specifications Impedance, Ohms 75 Mechanical Specifications Size Length, in [mm] Width/Dia., in [mm] 1.4 [35.56] 0.625 [16] Weight, lbs [g] 0.068 [30.84] Connector Type Contact Material and Plating Body Material and Plating Dielectric Type N Female Silver Brass, Nickel PTFE . Compliance Certifications (visit www.Pasternack.com for current document) RoHS Compliant Yes Plotted and Other Data Notes: Values at 25 °C, sea level 75 Ohm N Female Connector Clamp/Solder Attachment For RG59, RG62, .480 inch D Hole from Pasternack Enterprises has same day shipment for domestic and International orders. Our RF, microwave and fiber optic products maintain a 99% availability and are part of the broadest selection in the industry. Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price, inventory and certifications: 75 Ohm N Female Connector Clamp/Solder Attachment For RG59, RG62, .480 inch D Hole PE4516 URL: http://www.pasternack.com/n-female-standard-rg59-rg62-connector-pe4516-p.aspx PE4516 REV 1 © 2013 Pasternack Enterprises All Rights Reserved PE4516 REV RG62 USES PTFE INSERT. INSERT PTFE BEFORE CONTACT. TAPER END FIRST. NOTE: 2. FORM BRAID OVER CLAMP NUT (4). TRIM BRAID BACK TO SHOULDER. CUT DIELECTRIC & CENTER CONDUCTOR TO DIMENSION SHOWN. DO NOT NICK CENTER CONDUCTOR. SOLDER CONTACT TO CENTER CONDUCTOR. REMOVE EXCESS SOLDER. DO NOT OVER HEAT DIELECTRIC. INSERT CABLE ASSEMBLY INTO BODY & TIGHTEN. 1. SLIDE CLAMP NUT (1), WASHER (2) & GASKET (3) OVER CABLE. STRIP CABLE AS SHOWN. DO NOT NICK BRAID WHILE CUTTING JACKET. TAPER END OF BRAID TO PERMIT ASSEMBLY OF BRAID CLAMP (4). SLIDE BRAID CLAMP (4) OVER BRAID & SEAT AGAINST CABLE. ASSEMBLY PROCEDURES FSCM NO. 53919 PE4516 DWG TITLE CAD FILE 052102 SCALE N/A SIZE A 127 NOTES: 1. UNLESS OTHERWISE SPECIFIED ALL DIMENSIONS ARE NOMINAL. 2. ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE AT ANY TIME. 3. DIMENSIONS ARE IN INCHES [mm]. 4. FITS MIL-C-17 AND EQUIVALENT CABLES. 75 Ohm N Female Connector Clamp/Solder Attachment For RG59, RG62, .480 inch D Hole PE4516 CAD Drawing 2