MHV Male Right Angle Connector Clamp/Solder Attachment For RG213, RG214, RG8, RG9, RG11, RG225, RG393 TECHNICAL DATA SHEET PE4709 MHV Male Right Angle Connector Clamp/Solder Attachment For RG213, RG214, RG8, RG9, RG11, RG225, RG393 Configuration Connector Connector Interface Type Cable Attachment Method (Shield/Contact) Body Style MHV Male RG213,RG214,RG8,RG9,RG11,RG225,RG393 Clamp/Solder Right Angle Electrical Specifications Impedance, Ohms 50 Mechanical Specifications Size Length, in [mm] Width/Dia., in [mm] Height, in [mm] 1.84 [46.74] 0.75 [19] 1.21 [30.73] Weight, lbs [g] 0.158 [71.67] Connector Type Contact Material and Plating Coupling Nut Material and Plating Body Material and Plating Dielectric Type MHV Male Silver Brass, Nickel Brass, Nickel PTFE . Compliance Certifications (visit www.Pasternack.com for current document) RoHS Compliant Yes Plotted and Other Data Notes: Values at 25 °C, sea level MHV Male Right Angle Connector Clamp/Solder Attachment For RG213, RG214, RG8, RG9, RG11, RG225, RG393 from Pasternack Enterprises has same day shipment for domestic and International orders. Our RF, microwave and fiber optic products maintain a 99% availability and are part of the broadest selection in the industry. Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price, inventory and certifications: MHV Male Right Angle Connector Clamp/Solder Attachment For RG213, RG214, RG8, RG9, RG11, RG225, RG393 PE4709 URL: http://www.pasternack.com/mhv-male-standard-rg213-rg214-rg8-rg9-rg11-rg225-rg393-connector-pe4709-p.aspx PE4709 REV 1 © 2013 Pasternack Enterprises All Rights Reserved 2. FORM BRAID OVER CLAMP NUT (3). TRIM BRAID BACK TO SHOULDER. CUT DIELECTRIC TO DIMENSION SHOWN. DO NOT NICK CENTER CONDUCTOR. SOLDER CONTACT TO CENTER CONDUCTOR. REMOVE EXCESS SOLDER. DO NOT OVER HEAT DIELECTRIC. INSERT CABLE ASSEMBLY INTO BODY & TIGHTEN. 1. SLIDE CLAMP NUT (1) & GASKET (2) OVER CABLE. STRIP CABLE AS SHOWN. DO NOT NICK BRAID WHILE CUTTING JACKET. TAPER END OF BRAID TO PERMIT ASSEMBLY OF BRAID CLAMP (3) SLIDE BRAID CLAMP(3) OVER BRAID & SEAT AGAINST CABLE. ASSEMBLY PROCEDURES PE4709 REV FSCM NO. 53919 PE4709 DWG TITLE CAD FILE 060302 SCALE N/A SIZE A 127 NOTES: 1. UNLESS OTHERWISE SPECIFIED ALL DIMENSIONS ARE NOMINAL. 2. ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE AT ANY TIME. 3. DIMENSIONS ARE IN INCHES [mm]. 4. FITS MIL-C-17 AND EQUIVALENT CABLES. MHV Male Right Angle Connector Clamp/Solder Attachment For RG213, RG214, RG8, RG9, RG11, RG225, RG393 PE4709 CAD Drawing 2