T-1, (3-mm) Round, Bi-level PCB Mount LED Indicator, J78H Series The J78H is designed to minimize cross illumination especially in back-lighting applications. For best results transparent LEDs should be used with this holder to take advantage of the spot lighting effect, although all standard lamps can be used. Designed to save panel space, the assembly measures just over 4.3 mm(0.170") in width and can be CMOS driven to save components. Long arrays should be located on a pitch of 4.4 mm(0.173") to avoid crowding and tolerance build-up. This series can also be supplied with pinout reversed from that shown by adding “-RL” to the order code of the part number. 4.3 (0.17) 10.5(.415) 0.5±.25 3.0 typ IDEA 78H 5.08 9.65 LED 1 IDEA 78H 2.54 3.5 min Anode typ 2.54 LED 2 6.86 2.54 + – (Standard Pinout) Specify part desired as follows: J78H/Order Code LED1 + Order Code LED 2 For example: “J78H/IT+GT” designates an assembly with a red LED on top and a green LED on the bottom. “J78H/(IT+GT)-RL” designates the same assembly with leads reversed. ORDER CODE AND INFORMATION (ALL RATINGS AT 25°C AMBIENT) LED Lamp Epoxy & Type TInted Diffused Color Typical Characteristics Order Code Peak Vf (V) Iv (mcd) 2Θ1/2 λ (nm) @If=20mA @If= 2 mA (Deg) Recom. Op. If (mA) Red I 639 1.8 4.0 50 2 - 10 Green G 575 1.7 2.5 60 2 - 10 Yellow Y 591 1.85 4.0 45 2 - 10 * Specifications subject to change without notice. Dimensions are in mm±0.25 unless stated otherwise. IDEA, Inc., 1351 Titan Way, Brea, CA 92821 Ph:714-525-3302, 800-LED-IDEA; Fax: 714-525-3304 Catalog 995A