CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS LG Radial Lead Type, Higher Capacitance series Higher Capacitance, Low ESR, High ripple current. Load life of 2000 hours at 105°C. Radial lead type : Lead free flow soldering condition correspondence Adapted to the RoHS directive (2002/95/EC). LG Higher Capacitance LF Specifications Item Performance Characteristics Category Temperature Range –55 to +105°C Rated Voltage Range 2.5 to 16V Rated Capacitance Range 330 to 3900µF Capacitance Tolerance ± 20% at 120Hz, 20°C tan δ Not more than value of Standard ratings at 120Hz, 20°C ESR ( 1) Not more than value of Standard ratings at 100kHz, 20°C Leakage Current ( 2) Not more than value of Standard ratings. After 2 minute's application of rated voltage. Characteristics of Temperature Z+105°C / Z+20°C 1.25 Impedance Ratio 1.25 Z - 55°C / Z + 20°C (100kHz) After 2000 hours' application of rated voltage Endurance at 105°C, capacitors meet the specified value for life characteristics listed at right. After 1000 hours' application of rated voltage Damp Heat at 60°C 90%RH, capacitors meet the specified value for life characteristics listed at right. Resistance to Soldering Heat Marking 20°C To comply with recommended conditions for reflow soldering. Pre-heating shall be done at 150 to 200°C and for 60 to 180 sec. Peak temp. is 265°C, within 10 sec. Measurement for solder temperature profile shall be made at a point on the terminal nearest where the terminals protrude through the soldering side of PC board. Capacitance change Within ± 20% of initial value ( 3) tan δ 150% or less of the initial specified value ESR ( 1) 150% or less of the initial specified value Leakage current ( 2) Initial specified value or less Capacitance change Within ± 20% of initial value ( 3) tan δ 150% or less of the initial specified value ESR ( 1) 150% or less of the initial specified value Leakage current ( 2) Initial specified value or less Capacitance change Within ± 10% of initial value ( 3) tan δ 130% or less of the initial specified value ESR ( 1) 130% or less of the initial specified value Leakage current ( 2) Initial specified value or less Navy blue print on the case top. ( 1) ESR measurements should be made at a point on the terminal nearest the end seal of the capacitor. ( 2) Conditioning : If there is doubt about the measured result, measurement should be made again after the rated voltage is applied for 120 minutes at the temperature of 105°C. ( 3) Initial value : The value before test of examination of resistance to soldering. CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS LG series Type numbering system (Example : 4V 1200µF) Dimensions Capacitance Lot. No. 1 Silvered lead Wire Laminated Case 2 3 4 5 6 7 8 9 10 11 12 P ±0.5 LG 122 g 741 φ D+0.5 MAX P L G 0 G 1 2 2 M CO 1 Size code Configuration φd Series Voltage (g:4V) L+0.5MAX Capacitance tolerance (± 20%) 15MIN Rated Capacitance (1200µF) 4MIN Rated voltage (4V) Series name Voltage V Code 2.5 e 4 g 6.3 j 10 A 16 C Type Configuration φD × L (mm) Size φ8 × 9L φ8 × 12L φ 10 × 13L φD 8.0 8.0 10.0 L 8.5 3.5 11.5 3.5 12.5 5.0 0.6 0.6 0.6 P φd Code 8×9 CO 8 × 12 DO 10 × 13 DO Standard ratings 2.5 (0E) 4 (0G) 6.3 (0J) 10 (1A) 16 (1C) 2.8 4.6 7.2 11.5 18.4 ESR Rated ripple (mΩ) (mArms) (20˚C / 100kHz) (105˚C / 100kHz) Case Size φD × L (mm) tan δ Leakage Current (µA) 1800 8×9 0.08 900 9 6000 PLG0E182MCO1 2200 8 × 12 0.08 1100 8 6700 PLG0E222MDO1 3900 10 × 13 0.08 1950 8 7000 PLG0E392MDO1 1200 8×9 0.08 960 9 5900 PLG0G122MCO1 1800 8 × 12 0.08 1440 9 6500 PLG0G182MDO1 2700 10 × 13 0.08 2160 8 6900 PLG0G272MDO1 820 8×9 0.08 1033 9 5700 PLG0J821MCO1 1200 8 × 12 0.08 1512 9 6100 PLG0J122MDO1 1800 10 × 13 0.08 2268 8 6600 PLG0J182MDO1 560 8×9 0.08 1120 11 5100 PLG1A561MCO1 820 8 × 12 0.08 1640 10 5800 PLG1A821MDO1 1200 10 × 13 0.08 2400 9 6200 PLG1A122MDO1 330 8×9 0.08 1056 13 4700 PLG1C331MCO1 470 8 × 12 0.08 1504 11 5400 PLG1C471MDO1 820 10 × 13 0.08 2624 11 5600 PLG1C821MDO1 Rated Voltage Surge Voltage Rated Capacitance (V) (V) (µF) Code Code Design, Specifications are subject to change without notice. Printed in Japan T.2007.B.3C