F-215 TM HLCD–20–06.00–TD–TR–1 SYSTEM (0,50 mm) .0197" HLCD SERIES HIGH SPEED HERMAPHRODITIC CABLE ® Mates with: LSHM SPECIFICATIONS Choice of end options For complete specifications and recommended PCB layouts see www.samtec.com?HLCD Cable: 38 AWG 50Ω coax cable Signal Routing: 50Ω Single-Ended Plating: Au over 50µ" (1,27 µm) Ni Operating Temp Range: -25°C to +105°C SI Performance: Testing Now! RoHS Compliant: Yes • Screw downs 38 AWG micro ribbon coax cable 20, 30, 40 or 50 positions per row Notes: Cable lengths longer than 40.00" (1 meter) are not supported with S.I. test data. HLCD POSITIONS PER ROW Design your High Speed Cable with Samtec’s High Speed Cable Solutionator® at www.samtec.com/hdr –20, –30, –40, –50 Some lengths, styles and options are non-standard, non-returnable. A Vertical to Vertical (21,84) .860 Vertical to Right Angle Vertical to Reverse Right Angle Right Angle to Right Angle Right Angle to Reverse Right Angle Reverse Right Angle to Reverse Right Angle WIRE LENGTH END NO. 1 END 1 OPTION –“XX.XX” –TR = Vertical, Top Right Leave blank for no screw down. Screw down not available for –TD TH, –BD & –BH options. = Wire Length in Inches (43,7 mm) 01.72" minimum (Standard Sizes) END TO END END NO.2 B = Vertical, Bottom Right = Vertical, Bottom Left B XH, XD –020 (22,23) .875 (18,42) .725 –030 (24,77) .975 (26,04) 1.025 –040 (32,39) 1.275 (33,66) 1.325 –050 (40,01) 1.575 (41,28) 1.625 END OPTION C D XL, XR (16,51) .650 (6,02) .237 XD XH (20,02) .788 (6,71) .264 –BL C (28,85) 1.136 XR, XL –TL = Vertical, Top Left –BR (25,35) .998 NO. OF POSITIONS Screw Down option available OAL = Wire Length +A 01 02 N-1 END NO.1 N D END NO. 1 (–TR SHOWN) S = Screw down in PCB END NO. 2 END 2 OPTION –TR Leave blank for no screw down. Screw down not available for –TD TH, –BD & –BH options. = Vertical, Top Right –TL = Vertical, Top Left –BR = Vertical, Bottom Right –BL = Vertical, Bottom Left –TD –TD = Right Angle, Top = Right Angle, Top –TH –TH = Reversed Right Angle, Top = Reversed Right Angle, Top –BD –BD = Right Angle, Bottom = Right Angle, Bottom –BH –BH = Reversed Right Angle, Bottom = Reversed Right Angle, Bottom END NO. 2 (–TD SHOWN) WWW.SAMTEC.COM Due to technical progress, all designs, specifications and components are subject to change without notice. S = Screw down in PCB WIRING OPTION –1 = Pin 1 to Pin 1 –2 = Pin 1 to Pin 2 –3 = Pin 1 to Pin N-1 –4 = Pin 1 to Pin N