Filename: tfs140e.doc Version 1.4 VI TELEFILTER 19.05.2003 Filter specification Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: 23 0 860 860 TFS140E 1/5 °C dBm || -1.2 pF || -1,2 pF Characteristics Remark: Reference level for the relative attenuation arel of the TFS140E is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 140,455 MHz without tolerance. The given values for the relative attenuation arel and for the group delay ripple have to be reached at the frequencies given below even if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc. Data typ. value ae Insertion Loss (reference level) Nominal Frequency fN Relative Attenuation arel fN ± 25 kHz fN ± fN ± fN ± 75 125 455 kHz kHz kHz - tolerance / limit max. 5 - - - 140,455 dB MHz - max. 3 dB - min. min. min. 8 20 60 dB dB dB Intermodulation **** - max. -88 dB Input power - max. 5 - - 40 °C ... + 85 °C ... fN ± ... fN ± 125 455 Operating Temperature Range kHz kHz OTR Frequency Inversion Temperature Temperature Coefficient of Frequency Storage Temperature Range TCf ** 25 °C - -0,035 ppm/K2 - - dBm - 54 °C ... + 100 °C *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) ∆fc(Hz) = Tcf(ppm/K) x (T - To) x fCAT (MHz) ****) For two – 20dBm input signals @ fN + 0,060 MHz and fN + 0,120 MHz @ fN - 0,060 MHz and fN - 0,120 MHz Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs140e.doc Version 1.4 VI TELEFILTER 19.05.2003 Filter specification TFS140E 2/5 Construction and Pin Configuration (All Dimensions in mm) . TFS 140 E R21 Pin 4 Pin 5 Pin 9 Pin 10 Pin 1,2,3,6,7,8 - - Output - Output RF Return - Input - Input RF Return - Ground Date Code Date code: N P R ... year + week 2001 2002 2003 R0.15 50 Ω matching circuit L1 9 4 10 5 L2 C2 C1 1,2,3,6,7,8 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs140e.doc Version 1.4 VI TELEFILTER 19.05.2003 Filter specification TFS140E 3/5 Stability Characteristics After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 18 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N 4. Resistance to solder heat (reflow): reflow possible: twice max.; for temperature conditions, please refer to the attached "Air reflow temperature conditions" on page 4; Packing Tape & Reel: DIN IEC 286 – 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer 3000 min 300 mm min 500 mm min 300 mm EMBOSSED CARRIER TAPE Tape (all dimensions in mm) Do W Po Do E F G (min) P2 P1 D1(min) Ao Bo CT : : : : : : : : : : : : 24± 0,3 4 ± 0,1 1,5 + 0,1 1,75 ± 0,1 7,5 ± 0,1 0,6 2 ± 0,1 8 ± 0,1 1,5 5,6 ± 0,1 11,8 ± 0, 21,5 ± 0,1 Po P 2 E A D CT o F 1 W Bo G P1 COVER TAPE W 2 Reel (all dimensions in mm): A : W1 : W2 (max) : 330 24,4 +2 30,4 N (min) : 60 C : 13 +0,5/-0,2 A C N W 1 The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape. Markings on the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on its right. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs140e.doc Version 1.4 VI TELEFILTER 19.05.2003 Filter specification TFS140E 4/5 Air reflow temperature conditions 1st and 2nd air reflow profile pre-heating periods 150 °C - 170 °C 60 sec. - 90 sec. Name: Temperature: Time: main-heating periods over 200 °C 20 sec. - 25 sec. peak temperature 255 °C ± 5 °C Chip-mount air reflow profile 260 240 220 200 temperature / °C 180 160 140 120 100 80 60 40 20 0 0 20 40 60 80 100 120 140 160 180 200 220 240 time / sec. Table for temperature vs. time during the air reflow process Tolerance of temperatures: ± 5 °C time / sec. 0 10 20 30 40 50 60 70 80 90 100 110 120 130 temperature / °C 23 34 46 60 80 103 121 134 143 150 154 156 158 159 time / sec. 140 150 160 170 180 190 195 200 205 210 215 220 230 240 temperature / °C 160 161 164 170 180 205 230 255 230 205 180 165 140 120 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs140e.doc VI TELEFILTER Version 1.4 Filter specification 19.05.2003 TFS140E 5/5 History Version Reason of Changes Name Date 1.4 - Add history - Change date code from month to week. - Change pin 1 marker from tft to a filled point. - Change stability characteristics. - Change packing information. - Add maximum input power. Dr. Wall 19.05.2003 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.